Panasonic PT-D6000E 사용 설명서 - 페이지 17

{카테고리_이름} Panasonic PT-D6000E에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-D6000E 42 페이지. Dlp based projector commercial use

Removing and attaching the projection lens

 Removing the projection lens

from the projector

1. Switch off the POWER button on the projector.

2. Rotate the lens cover counterclockwise and remove.

3. While pressing the lens release button, rotate the

projection lens counterclockwise, and remove the

projection lens.

Lens release button

NOTE:

• Do not touch the lens signal receiver. Dust or dirt may cause

defective contact.

• Do not touch the surface of the projection lens with your bare

hands.

• Store the replaced lens where it will be free from vibration and

impact.

Lens cover

Projection lens

 Attaching the projection lens to

the projector

1. Switch off the POWER button on the projector.

 When the lens cover is attached, rotate counterclockwise

and remove.

2. Align the guide of the projection lens with the guide

groove in the projector, and then insert the lens.

3. Rotate the projection lens clockwise until it clicks into

place.

4. To attach the slot, align the slot of the lens cover (see *1)

with the arrow tip located on the body of the projector

(see *2). Rotate clockwise until it reaches the arrow's

end mark

(see *3) to attach.

NOTE:

• Make sure the projection lens is attached securely by rotating

the projection lens counterclockwise.

Setting up

Lens cover

NGLISH - 17