Panasonic PT-F200NTU - LCD Proj XGA 400:1 3500 Lumens VGA Svid Wrls Cpnt 사용자 설명서 - 페이지 37
{카테고리_이름} Panasonic PT-F200NTU - LCD Proj XGA 400:1 3500 Lumens VGA Svid Wrls Cpnt에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-F200NTU - LCD Proj XGA 400:1 3500 Lumens VGA Svid Wrls Cpnt 49 페이지. Panasonic pt-f200: product brochure
Panasonic PT-F200NTU - LCD Proj XGA 400:1 3500 Lumens VGA Svid Wrls Cpnt에 대해서도 마찬가지입니다: 빠른 매뉴얼 (1 페이지), 고급 운영 매뉴얼 (33 페이지), 브로셔 및 사양 (6 페이지)
페이지 인쇄
Using WebBrowser
Monitor information window
This page indicates the projector status.
To access this page from other pages, click [Status] at the left of the window.
Monitored information
On this window, click the [Status information] tab.
The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View]
[Reload Page].
If [SELF TEST Error(Detail)] appears on the
monitored information window, click it to view the error
details.
If [FAILED] appears
Item
MAIN CPU BUS
FAN
INPUT/OUTPUT AIR TEMP.
LAMP REMAIN TIME
LAMP STATUS
ARF UNIT
INPUT AIR TEMP.SENSOR
OUTPUT AIR TEMP.SENSOR
BATTERY
(cont.)
Description
There is a problem with a microcontroller circuit. Contact your dealer.
There is a problem with the fan or fan drive circuit. Contact your dealer.
Excessive temperature by the air intake or around the lamp area.
The following may be causing the problem.
• The ambient temperature is too hot; the projector may be near a heater
• The exhaust vent is obstructed
The lamp has been used for longer than its rated useful life, and it is time to replace it.
The lamp could not be lit.
Allow the bulb of the light source to cool, and then turn on the projector.
ARF UNIT is not installed or remaining filter level is low.
See instruction manual of the projector for detail.
There is a problem with the air intake temperature sensor. Contact your dealer.
There is a problem with the exhaust temperature sensor. Contact your dealer.
The battery must be replaced. Contact your dealer.
37
Network information
On this window, click the [Network status] tab.