Panasonic PT-F200NTU/PT-FW100NTU 사용자 설명서 - 페이지 4

{카테고리_이름} Panasonic PT-F200NTU/PT-FW100NTU에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-F200NTU/PT-FW100NTU 49 페이지. Network function edition

Notes on Using Wireless Connection

Wireless connection function of the projector uses radio waves in the 2.4 GHz band.

A radio station license is not required, but be sure to read and fully understand the following items before use.

Do not use near other wireless equipment.

The following equipment may use radio waves in the same band as the projector.

When the projector is used near these devices, radio wave interference may make communication impossible, or the

communication speed may become slower.

• Microwave ovens, etc.

• Industrial, chemical and medical equipment, etc.

• In-plant radio stations for identifying moving objects such as those used in factory manufacturing lines, etc.

• Designated low-power radio stations

If at all possible, avoid the use of cellular phones, TV sets or radios near the projector.

Cellular phones, TV sets, radios and similar devices use different radio bands from the projector, so there is no effect on

wireless communication or the transmission and reception of these devices. However, radio waves from the projector may produce

audio or video noise.

Wireless communication radio waves cannot penetrate steel reinforcements, metal, concrete,

etc.

Communication is possible through walls and floors made from materials such as wood and glass (except glass containing

wire mesh), but not through walls and floors made from steel reinforcements, metal, concrete, etc.

Avoid using the projector in locations prone to static electricity.

If the projector is used in a location prone to static electricity, such as on a carpet, the wireless LAN or wired LAN connection

may be lost.

If this happens, eliminate the source of static electricity or electromagnetic noise and reconnect to the wireless LAN or wired

LAN.

In rare cases static electricity or electromagnetic noise may make it impossible to establish a connection to the LAN.

If this happens, press the power button on the remote control or on the projector to power off the projector temporarily.

After the cooling fan stops operating (after the power monitor on the projector changes from orange to red), power on the

projector and reconnect to the LAN.

Using the projector outside the country

It is forbidden to take the projector outside the country or region where you purchased it, so use it only in the said country or

region. Also, note that depending on countries or regions there are restrictions on the channels and frequencies at which you

can use the wireless LAN.