Panasonic PT-JX200WE 설치 지침 매뉴얼 - 페이지 13

{카테고리_이름} Panasonic PT-JX200WE에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PT-JX200WE 30 페이지.

Installation

The main procedures for using this product to install a projector (optional) on a wall or ceiling are as follows.

Before the installation work, be sure to shut off the power supply to the room by, for example, shutting off the

wiring circuit breaker.

1) Preparing the adapter cover ( page 13)

2) Mounting the attachment plate to a wall or ceiling ( page 13)

3) Changing the orientation of the main unit of the projector ( page 19)

4) Mounting the projector mount bracket to the projector ( page 20)

5) Mounting the projector to the attachment plate ( page 22)

6) Connecting the power cord to the projector ( page 25)

7) Adjusting the projection position ( page 27)

String attachment hole

Check the height, space, and structure of the installation location and then determine the installation position on

the wall or ceiling in advance while referring to "Installation position" ( page 11). Use the centre of the

projector pole as a guide for positioning.

The mounting method for the attachment plate differs depending on the structure of the ceiling. Install it in a

way that is appropriate for the ceiling to be mounted on. Before performing the mounting work, check that the

hanging bolt and the installation location of the mount bracket is strong enough to withstand the weight of both

the projector and the mount bracket.

Attention

z When mounting the product to the ceiling with hanging bolts, be sure to use commercially available

hanging bolts, hexagonal nuts, flat washers, spring washers, and anchor nuts or curled plugs for the M10

thread size.

z When mounting the product to a concrete ceiling with hanging bolts, drill anchor nut or curled plug

mounting holes to match the size specified by the manufacturer.

z Securely tighten each nut, and if necessary take a measure such as using two nuts

or thread-locking fluid to prevent loosening.

z When mounting the product to a wall or ceiling with wood screws, make sure the

purchased commercially available wood screws with nominal diameter of 4.1 mm

(5/32") and 3.1 mm (1/8") can meet the requirement of at least 20 mm (25/32") thread

engagement with the wall or ceiling reinforcement.

1) Attach the string to the adapter cover.

z Pass the end of the string (end with the small loop)

through the hole in the adapter cover and then

attach the string to the adapter cover as shown in the

following diagram.

Double nuts

ENGLISH - 13