Diamond Traffic Products Pegasus 빠른 설치 매뉴얼 - 페이지 3

{카테고리_이름} Diamond Traffic Products Pegasus에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Traffic Products Pegasus 3 페이지.

Version 1.1 9/10/2013

 You should be shown a screen indicating that Centurion has located and is now linked to

your Pegasus traffic counter.

 If the counter clock is off by more than a few seconds, you will be prompted to set the

Pegasus time and date to the computer's time by clicking on 'Set Counter to Computer

Time' button. You will then be directed to the 'Show Status' screen.

 Select 'Set System Configuration' then 'Data Collection Options': We recommend you

ignore 'Enable Lane Grouping'. Select 'Daily' for new file creation, this will cause new files

to begin at midnight (00:00). Place a check mark in the box to the right of 'Erase 1

No Mem', if not checked, the unit will stop collecting IF the number of files currently in

memory attempts to exceed '99'.



Click on 'Start Collecting Data' and enter a Site ID using your keyboard. You may also use

the two Info Lines if desired. You will also need to enable at least one lane. Click on the

'Next' arrow button.

 Enter Lane Info and Select 'Mode'. (Tanger currently uses 'Normal' for Mode).

 Select 'Sensor' type by using the drop down arrow; (Tanger currently uses Loop as

Sensors).

 Click on the 'Next' arrow button.

 Select 'One' under '# of Different Record Intervals During Day'. Select desired 'Record

Interval Length' by using the drop down arrow. (Currently Tanger uses 15 Minute as the

default interval). Click on the 'Next' arrow button.

At this point, power off the counter and disconnect the serial cable. All programming is currently

done and the unit now needs to be connected to the Loops for the remainder of programming.

Take the Pegasus to its installation site and connect the corresponding cables to the unit. Once

all of the cables have been connected to the Pegasus unit turn the unit back on.

The Pegasus unit will go through a quick self- test and return you to the 'Start Collecting' Menu.

To continue programming where you left off, press enter until you see 'Tuning Loops' at this point

we need to verify that the counts match actual traffic. If the numbers on the display match the

actual traffic press 'Enter'.

 At the 'Select Mode to Start' Screen select 'Now' and press 'Enter'.

 At the 'Select Mode to Stop' Screen Select 'Never' and press 'Enter'.

Programming is now complete; Press 'Enter' and the display will blank in a few seconds. The unit

is in a low power sleep mode.

'Enter' key followed by #4 key and 'Enter'. This will take you into the Monitor Lanes function.

Count data displayed in this screen will be recorded to a file and the displayed number cleared at

the start of each interval. If you notice an '*', the unit is in a preset active mode and will begin to

store data at the beginning of the next interval.

Diamond Traffic Products, Inc.

Do NOT turn off the

power. To verify proper operation press the

Pegasus: Quick Installation Guide

When

Page 3