Diamond Vantage TS400 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Diamond Vantage TS400에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamond Vantage TS400 20 페이지.

16. DON'T OVERREACH. Keep proper footing and balance at all times.

17. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safer performance.

18. DISCONNECT TOOL. When not in use, before servicing, or when changing attachments—wheels, bits, cutters, etc—all

tools should be disconnected.

19. AVOID ACCIDENTAL STARTING. Be sure switch is off when plugging in.

20. USE RECOMMENDED ACCESSORIES. Consult the operator's manual for recommended accessories. The use of

improper accessories may risk injury.

21. NEVER STAND ON TOOL. Serious injury could occur if the tool is tipped or if the cutting tool is unintentionally

contacted.

22. CHECK THE TOOL FOR DAMAGED PARTS BEFORE A FURTHER USE. Check for alignment of moving parts, binding of

moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other

part that is damaged must be properly repaired or replaced by an authorized service center to avoid risk of personal

injury. Always check the machine for loose bolts before starting.

23. NEVER LEAVE TOOL RUNNING UNATTENDED. After machine is switched "off", do not leave tool until it comes to a

complete stop.

24. USE THE CORRECT EXTENSION CORDS. When using an extension cord, be sure to use one heavy enough to carry the

current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and

overheating. Extension cord tables (refer to page 13) show the correct size to use depending on cord length and

nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage numbers the heavier the cord.

25. DO NOT ABUSE CORD. Never yank cord to disconnect from electrical outlet. Keep cord away from heat, oil, and sharp

edges.

26. ELECTRICAL SHOCK. Never touch electrical wires or components while the engine is running. Exposed, frayed or

worn electrical wires and plugs can be sources of electrical shock which could cause severe injury or burns. Do not

touch the plug with wet hands. Prevent contact with grounded surfaces, for example pipes, radiators, ranges and

refrigerator enclosures.

27. WHEN TOOL IS USED OUTDOORS, only use extension cords intended for outdoor usage.

28. NEVER operate this equipment when not feeling well due to fatigue, illness or taking medicine.

29. NEVER operate this equipment under the influence of drugs, alcohol or any medication.

30. ALWAYS make sure that the machine is on level ground before using

31. ALWAYS store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out

of the reach of children.

WARNING!

Sawing and drilling generates dust. Excessive airborne particles may cause irritation to eyes, skin and respiratory

tract. To avoid breathing impairment always employ dust controls and protection suitable to the material being

saw or drilled in accordance with OSHA (29 CFR Part 1910.1). Diamond blades improperly used are dangerous.

Comply with ANSI Safety Code B7.1 and OSHA covering speed, safety guards, flanges, mounting procedures,

general operating rules, handling, storage and general machine condition.

CALIFORNIA PROPOSITION 65 WARNING!

This product can expose you to chemicals including lead from lead-based paints, crystalline silica from bricks,

cement and other masonry products, and arsenic & chromium from chemically treated lumber, which are known

to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to

www.P65Warnings.ca.gov.

• 4 • diamondvantage.com