Panasonic PTL592U - LCD PROJECTOR 사용 설명서 - 페이지 21

{카테고리_이름} Panasonic PTL592U - LCD PROJECTOR에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic PTL592U - LCD PROJECTOR 48 페이지. Panasonic pt-l592u operating instructions

페이지 인쇄

If S-VIDEO or VIDEO has been selected as the input signal source, there may be times where the signal format is

not selected correctly, with the result that a normal picture is not projected. If this happens, select the correct signal

format by the following procedure. The default setting is " AUTO" .

Setting procedure

1. Press the MENU button to display the MENU screen.

2. Press the " " and " " buttons to select " PICTURE" .

3. Press the " <" and " >" buttons to display the PICTURE screen.

4. Press the " " and " " buttons to select " TV-SYSTEM" .

5. Press the " <" and " >" buttons to select either " AUTO" , " NTSC" , " PAL" , " SECAM"

or " NTSC 4.43" .

Select the appropriate signal format for the input signal while referring to the table below.

Horizontal scanning frequency [kHz]

AUTO

NTSC

NTSC 4.43

PAL

SECAM

NOTE:

The correct signal format may not be selected if, for instance, you are using a poor-quality signal source, such as

a dubbed video tape. Switching the signal format may give better results in such cases.

The setting screen and the MENU screen can both be cleared by pressing the MENU button.

Adjusting the volume

The volume can be adjusted by pressing the VOL (+/-) buttons on the remote control unit.

Remote control unit

Vertical scanning frequency [Hz] Color subcarrier frequency [MHz]

Automatically selects NTSC, PAL, SECAM or NTSC 4.43.

15.7

15.63

60.00

50.00

If the " +" button is pressed, the volume will increase,

and if the "-" button is pressed, the volume will

decrease.

NOTE:

If these buttons are pressed while the on-screen display

for another function is currently on the screen, the

volume will still be adjusted but the current volume

setting and the volume bar display will not appear.

The volume can also be adjusted from an on-screen

display menu. Refer to page 24 for details on how to do

this.

The volume output level will remain displayed on the

screen for approximately three seconds.

-20-

3.58

4.43

4.25 or 4.41