Diamondback 1260Sc 소유자 사용 설명서 - 페이지 13

{카테고리_이름} Diamondback 1260Sc에 대한 소유자 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamondback 1260Sc 20 페이지.
Diamondback 1260Sc에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄
Diamondback 1260Sc 소유자 사용 설명서
Functions
A.Console functions
1. Scope of application: SPIN BIKE
2. Operating voltage: 3V
3. Main functions: TIME, SPEED, DIST, CAL, RPM, PULSE, LOAD, WATT,
D. Paired with Battery Mode / Self-generated Electricity Mode / Adopter Mode
B.Button functions
1 ENTER/RESET KEY
1
Select TIME / DIST / CAL function
2 Confirmed the function
3
Press and hold the key for reboot
2 UP KEY
1
Press UP KEY to adjust values during setting
2
Press UP KEY to adjust LEVEL after START
3
DOWN KEY
Press DOWN KEY to adjust values during setting
1
2
Press DOWN KEY to adjust LEVEL after START
4
RESET KEY
Press RESET KEY under STAND BY mode to reboot the system
5
RECORDED DATA KEY:
When search for data, press RECORDED DATA key when the console is paused
When there is no data, the screen will show NO DATA, when there is data then it will
show the numbers of stored data
6
SAVE DELETE KEY:
When work out was paused and the LCD displayed shows STOP, press SAVE.DELETE
key and the data display area will show whether the data is saved. Press ENTER to
save the data.
Under RECORDED DATA mode, press SAVE.DELETE to delete the stored data that
you selected.
Under RECORDED DATA mode, press and hold the key for 5 seconds to delete all
stored data.
7
ANT+ ON/OFF KEY:
Press ANT+ ON/OFF once to activate ANT module function. And to turn off the function.
Power on/off :
A. Power on
1.
After powering on, the LCD will be in full display for one second and a long
sound will be heard (when the Beeping
2.
If there's no signal input in 4 seconds, the time will pause, the console will
BY mode.
B. Power off:
1. If there's no signal input in 4 minutes, the IC will enter SLEEP mode.
2. When there is signal input or button input, the console will WAKE UP.
PERSONALIZED WORKOUT DATA STORAGE, PERPETUAL CALENDAR,
TARGET TIME, TARGET DIST, TARGET CAL, TARGET WATT
function is on), enter TIME setting mode.
beeping
enter STAND