Diamondback 510Ic 소유자 매뉴얼

{카테고리_이름} Diamondback 510Ic에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamondback 510Ic 7 페이지.

CONSOLE OVERVIEW & GENERAL NOTES

A primary feature of the 510Ic is the ability to control and monitor the user's workout program via the brilliant LCD console. At any time, the user

may view their speed, RPM, elapsed time, distance, calories and pulse rate.

To provide power to the display console and computer, begin pedaling at a rate exceeding fifteen (15) revolutions per minute. The 510Ic Indoor

Cycle uses an on-board generator to supply power to the computer, console display and resistance control system while the unit is in use. While

the unit generates power for the current functions, a set of batteries is also charged to allow console operation for up to sixty (60) seconds without

pedaling. Should the battery ever run down or if the console does not light, connect the included power supply/adaptor to a 120V power source.

Plug the opposite end into the 510Ic power input jack found near the ground at the rear of the machine. Begin pedaling to recharge the battery.

To avoid damage and danger, use only the power supply/adaptor that was designed for the 510Ic. To maintain and extend the life of the battery, it

is necessary to charge the battery overnight, once per week.

To conserve energy, the console will automatically power down after sixty (60) seconds of inactivity.

CONSOLE KEYPAD FUNTION

Start-Stop Key.

Start or Stop workout.

Up & Down Arrow Keys.

Increase and decrease resistance level.

Setting selection

510Ic Owner's Manual

Mode / Enter.

Confirm setting or selection.

Fit Test Key.

Test heart rate recovery status.

Reset Key.

Press and hold for 2 seconds, computer will

reboot from user setting. Return to main menu

during preset workout value or stop mode.