Diamondback SE 설치 매뉴얼

{카테고리_이름} Diamondback SE에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diamondback SE 2 페이지. Hard tonneau cover for '15–up colorado & canyon with the 61.7" cargo box
Diamondback SE에 대해서도 마찬가지입니다: 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지), 설치 매뉴얼 (2 페이지)

페이지 인쇄
Diamondback SE 설치 매뉴얼
DiamondBackCovers.com / 800 935 4002
INSTALLATION GUIDE
75 minutes
Normal install time
PARTS INCLUDED:
Cab Panel
Center Panel
Tail Panel
PRE-INSTALLATION NOTES:
If you are installing a cab guard or headache rack, you should
mount it prior to mounting your DiamondBack cover. Refer to its
installation guide for details.
PREPARE THE CARGO BED & ATTACH THE COVER
Remove the trio of factory bolts that run under the bed rail along the
1
length of the driver-side cargo bed wall using a T30 Torx wrench.
Use those bolts to fasten a mounting bracket to the wall, its
2
clamp strip up and jutting inward.
clamp strip
Repeat steps 1–2 on the passenger side.
3
Place the center panel across
4
the center of bed, cheated
slightly toward the tailgate.
Make the sure the
arrow sticker on the
underside of the
center panel is
pointing toward the
tailgate.
Keep an eye out for these icons:
Mounting Brackets (2)
Cap Clamps (4)
'17–up Honda Ridgeline
IMPORTANT!
Important installation information
1/8"
Gas
Hex Key
Springs (4)
It's possible for one person to install a DiamondBack solo, but the whole
process, especially positioning the panels and adjusting the lock
rods, is much easier with two people.
Loosely affix the center panel to the truck by finger-tight-
5
ening a cap clamp at each of the four interior corners of
the underside of the center panel.
Attach the tail panel by angling it 90° from the bed rails, sliding its
6
driver-side, loop-shaped hinge knuckle fully onto the corresponding
center-panel hinge pin, then dropping its passenger-side, C-shaped
hinge knuckle fully onto its corresponding pin.
FIRST
Lower the tail panel into the closed position.
7
HD SE
Helpful Hints
Tips to assist installation
TOOLS REQUIRED:
9/16"
Ratchet Wrench
Socket
T30 Torx/Star
7/16"
Wrench
Socket
CONTINUED ON REVERSE >
CVR-5
SECOND