DiamondCore Tools CINK 사용자 설명서 - 페이지 10

{카테고리_이름} DiamondCore Tools CINK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DiamondCore Tools CINK 14 페이지. Self-contained system for cleanup of clay, clay water, pottery tools and accessories
DiamondCore Tools CINK에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지)

페이지 인쇄

MAINTENANCE

Winterizing The CINK (Cold Weather or Freezing Conditions)

CAUTION: The CINK is NOT designed to operate or be stored with water or clay in it during freezing conditions.

If freezing conditions are anticipated, remove all water and clay from the entire system. The manufacturer is not

responsible for any damage to the system, caused by the user, due to cold weather or freezing conditions.

Unplug the unit and empty

and clean both buckets and

the string filter housing.

DO NOT REPLACE ANY WATER.

Note: After the system has had a chance to dry, be sure to plug the hose fittings back into the pump and press the

blue or black lock tabs on the pump back down all the way.

Extended Non-Use of The CINK

If you don't plan to use The CINK for an extended period, we recommend unplugging the unit, removing all water

and clay from the system, cleaning the unit and allowing the filters to air dry. Follow instructions for Winterizing The

CINK above.

Water Cleanliness

You can eliminate odors in The CINK the same way you would with a slip bucket or clay trap. Because clay is an

organic material, it can sometimes create mold and a sulfuric stink. A capful of bleach, done in moderation, will kill

mold spores but won't affect reclaim. Chlorine from a pool supply store can also help mitigate the smell but isn't as

effective at eliminating mold. Essential oils can be added but will mask the odor rather than address the root causes.

Readjusting Drain Pipe Height

If water is leaking from the top of your drain pipe, it's likely that it isn't secured at the correct height with the drain

union nut. To stop the leak, loosen both nuts, then realign the drain pipe at the correct height. To do so:

Loosen the white and drain nuts.

diamondcoretools.com | [email protected]

Drain pump by lifting tabs

and pulling tubes from sockets.

Raise & align drain pipe;

retighten drain nut.

2 seconds

With tubes removed, purge the

pump of any water by plugging in

the power cord for only 2 seconds,

THEN UNPLUG THE POWER CORD.

Retighten the white nut to lock in

drain height.