Panasonic RQTV0080-1P 사용 설명서 - 페이지 5

{카테고리_이름} Panasonic RQTV0080-1P에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic RQTV0080-1P 24 페이지. Panasonic cd stereo system operating instructions model no. sc-pm23 rqtv0080-1p

페이지 인쇄

Step 2

- Inserting batteries into the remote control

S S tep 3 3

- DEMO function

Placement of speakers

Speakers are designed identically so that no left or right channel orientation is necessary.

Use only the supplied speakers.

The combination of the main unit and speakers provide the best sound. Using other speakers can damage the unit and sound

quality will be negatively affected.

Note

• Keep your speakers at least 10 mm (

• These speakers do not have magnetic shielding. Do not place them near televisions, personal computers or other devices easily inﬂ uenced

by magnetism.

• You cannot take the front net off the speakers.

Caution

• Use the speakers only with the recommended system. Failure to do so can damage the ampliﬁ er and

speakers, and can cause ﬁ re. Consult a qualiﬁ ed service person if damage occurs or if a sudden

change in performance is apparent.

• Do not attach these speakers to walls or ceilings.

■ Batteries

• Insert so the poles (+ and –) match those in the remote control.

• Remove if the remote control is not going to be used for a long period of

time. Store in a cool, dark place.

• Do not use rechargeable type batteries.

• Mishandling of batteries in the remote control can cause electrolyte

leakage, which may cause a ﬁ re.

Do not:

• mix old and new batteries;

• use different types of batteries at the same time;

• heat or expose to ﬂ ame;

• take apart or short-circuit;

• attempt to recharge alkaline or manganese batteries;

• use batteries if their covering has been peeled off.

■ Use

Aim at the remote control sensor, avoiding obstacles, at a maximum

range of 7 m (23 feet) directly in front of the unit.

Refer to page 6 for remote control signal sensor position.

When the unit is ﬁ rst plugged in, a demonstration of its functions may be

shown on the display.

If the demo setting is off, you can show a demonstration by selecting

"DEMO ON".

Press and hold [7, -DEMO].

The display changes each time the button is held down.

While in standby mode, select "DEMO OFF" to reduce power

consumption.

˝) away from the system for proper ventilation.