Panasonic RX-ED50 사용 설명서 - 페이지 16

{카테고리_이름} Panasonic RX-ED50에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic RX-ED50 24 페이지. Portable stereo cd system
Panasonic RX-ED50에 대해서도 마찬가지입니다: 사용 설명서 (24 페이지), 사용 설명서 (24 페이지)

페이지 인쇄

Tab for side "B"

Normal tape

Present state (e.g., elapsed play time of CD)

Present time

Tape counter

Downloaded From Disc-Player.com Panasonic Manuals

RQT5142

Side A

Tab for side "A"

To re-record

Hi-position tape

Detection hole

Before recording

Use household AC power or new batteries when recording

to avoid poor recordings caused by the batteries running

down.

Televisions can cause interference to recordings made on

this unit if the two are too close to each other.

Selection of tapes for recording

The unit automatically identifies the type of tape.

Normal position/TYPE

High position/TYPE

Metal position/TYPE

Metal position tapes can be used, but the unit will not be

able to record or erase them correctly.

Volume and sound quality in recording

•Recording level is set automatically.

•Recordings are unaffected by changes to sound quality.

Selecting reverse mode

Remote control only

Press [REV MODE].

and

: Both sides record (top side

: One side only records.

Erasing recordings

Insert the cassette with the side to be erased facing up.

Press [

TAPE/CD] to switch to TAPE mode.

Press [

Erasure prevention

The illustration shows how to remove the tabs to prevent

recording. To record on the tape again, cover as shown, be-

ing careful not to cover the high position discrimination hole.

To display the tape counter while recording

Remote control only

Press [DISPLAY].

Each time the button is pressed in CD, Radio, or AUX mode

To reset the tape counter

Press [C-RESET].

The counter resets to "000".

Your attention is drawn to the fact that recording pre-

recorded tapes or discs or other published or broadcast

material may infringe copyright laws.

O.K.

bottom side).