Panasonic SA-VK31 사용 설명서 - 페이지 4
{카테고리_이름} Panasonic SA-VK31에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic SA-VK31 40 페이지. Cd stereo system
페이지 인쇄
Set-up
Connect the AC power supply cord only after all other
connections have been made.
Preparation
Twist and pull off the vinyl tip of the antenna wires and
speaker cords.
5
AC power supply cord
Appliance inlet
Approx. 6 mm
Insertion of connector
Even when the connector is perfectly inserted, depending on
the type of inlet used, the front part of the connector may jut
out as shown in the drawing.
However there is no problem using the unit.
Note
Note
The included AC power supply cord is for use with this unit
only. Do not use it with other equipment.
For your reference
Information you enter into the unit's memory, except for time,
remains intact for up to a week after the AC power supply
cord is disconnected.
4
RQT7704
2
AM loop antenna
Stand the antenna up
on its base.
(R)
Connector
4
Video connection cable
1. Connect the video connection cable from
the VIDEO OUT terminal of the rear panel of
this unit to the VIDEO IN terminal of the TV.
2. Set the VIDEO OUT switch according to the
television set to be connected.
PAL :
When connecting a PAL system TV.
NTSC : When connecting an NTSC system TV.
For details, refer to the operating instructions of TV.
3
Speaker cords
Blue
Black
Red
Grey
3
2
1
Use only the supplied speakers.
The combination of the main unit and speakers provide the best
sound. Using other speakers can damage the unit and sound quality
will be negatively affected.
Caution
•
Use the speakers only with the recommended
system. Failure to do so may lead to damage
to the amplifier and/or the speakers, and may
result in the risk of fire. Consult a qualified
service person if damage has occurred or if
you experience a sudden change in
performance.
•
Do not attach these speakers to walls or
ceilings.
(L)
1
FM indoor antenna
Adhesive tape
Affix where
reception is
best.
Connect the left (L)
side in the same way.
Red (+)
Black (–)
Blue (–)
Grey (+)