DIAQUIP QHS-400 운영자 매뉴얼 - 페이지 4

{카테고리_이름} DIAQUIP QHS-400에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DIAQUIP QHS-400 18 페이지. Electric handsaw

페이지 인쇄

GENERAL SAFETY INSTRUCTIONS

General Power Tool Safety Warnings - Service

a. Have your power tool serviced by a qualified repair person using only identical

replacement parts. This will ensure that the safety of the power tool is maintained.

Symbols used in this manual

V.............Volts

A.............Amperes

Hz...........Hertz

W............Watt

~.............Alternating current

........... Rated speed

min

........Revolutions or reciprocation per minute

-1

.....Warning of general danger

.....Read these instructions

.....Always wear eye protection

.....Always wear a dust mask.

.....Always wear hearing protection

.....Wear safety-approved hard hat

.....DANGER! Keep hands away from cutting area and the blade.

Do not dispose of electric tools, accessories and

packaging together with household waste material

/06

SAFETY INSTRUCTIONS FOR

CUTTING-OFF OPERATIONS

WWW.DIAQUIP.CO.UK

Cut-off machine safety warnings

a. The guard provided with the tool must be securely attached to the power tool

and positioned for maximum safety, so the least amount of wheel is exposed

towards the operator. Position yourself and bystanders away from the plane

of the rotating wheel. The guard helps to protect the operator from broken wheel

fragments and accidental contact with wheel.

b. Use only diamond cut off wheels for your power tool. Just because an

accessory can be attached to your power tool, it does not assure safe

operation.

c. The rated speed of the accessory must be at least equal to the maximum

speed marked on the power tool. Accessories running faster than their rated

speed can break and fly apart.

d. Wheels must be used only for recommended applications. For example: do

not grind with the side of a cut-off wheel. Abrasive cut-off wheels are intended for

peripheral grinding, side forces applied to these wheels may cause them to shatter.

e. Always use undamaged wheel flanges that are of correct diameter for your

selected wheel. Proper wheel flanges support the wheel thus reducing the

possibility of wheel breakage.

f. The outside diameter and the thickness of your accessory must be within

the capacity rating of your power tool. Incorrectly sized accessories cannot be

adequately guarded or controlled.

g. The arbor size of wheels and flanges must properly fit the spindle of the power

tool. Wheels and flanges with arbor holes that do not match the mounting hardware

of the power tool will run out of balance, vibrate excessively and may cause loss of

control.

h. Do not use damaged wheels. Before each use, inspect the wheels for chips

and cracks. If power tool or wheel is dropped, inspect for damage or install an

undamaged wheel. After inspecting and installing the wheel, position yourself

and bystanders away from the plane of the rotating wheel and run the power

tool at maximum no load speed for one minute. Damaged wheels will

normally break apart during this test time.

/07