Panasonic SCAK220 - MINI HES W/CD PLAYER 사용 설명서 - 페이지 12
{카테고리_이름} Panasonic SCAK220 - MINI HES W/CD PLAYER에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Panasonic SCAK220 - MINI HES W/CD PLAYER 16 페이지. Cd stereo system model no. sc-ak220
Panasonic SCAK220 - MINI HES W/CD PLAYER에 대해서도 마찬가지입니다: 사용 설명서 (16 페이지), 사용 설명서 (32 페이지)
페이지 인쇄
Other functions
AUX
External unit connections
Rear panel of
this unit
•
An analogue player with a built-in phono equalizer can be connected.
•
For details, refer to the instruction manual of the units which are to
be connected.
•
When units other than those described above are to be connected,
please consult your audio dealer.
Using an external unit
(See above for external unit connection.)
1. Press [AUX].
The unit comes on.
2. For listening: Proceed to step 3.
For recording: Press [a, REC] (recording starts).
3. Start playback from the external source. (For details, refer to the
external unit's instruction manual.)
Using headphones (not included)
Reduce the volume level and connect the headphones.
Plug type: 3.5 mm stereo
Note
Avoid listening for prolonged periods of time to prevent hearing damage.
12
RQT7531
PHONES
VOLUME
R
L
(R)
(L)
Analogue player
(not included)
Turning the demo function on/off
When the unit is first plugged in, a demonstration of its functions may
be shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON".
Press and hold [DISP, –DEMO].
The display changes each time the button is held down.
NO DEMO (off) ↔ DEMO ON (on)
While in the standby mode, select "NO DEMO" to reduce power
consumption.
Note
DEMO function cannot be turned on when Dimmer is on.
Auto-off function
Remote control only
When CD or tape is selected as the source
To save power, the unit turns off if it is left unused for ten minutes.
This function does not work if the source is tuner or AUX.
Press [SHIFT] + [AUTO OFF].
"AUTO OFF" is shown on the display.
The setting is maintained even if the unit is turned off.
If you select tuner or AUX as the source, "AUTO OFF" goes out. It
comes on again when you select CD or tape.
To cancel
Press [SHIFT] + [AUTO OFF] again.
Setting the time
Remote control only
This is a 24-hour clock.
1
Switch on the power.
2
Press [SHIFT] + [CLOCK/TIMER] to select "CLOCK".
Every time you press the button:
CLOCK
PLAY
REC
Previous display
3
(Within 7 seconds or so)
Press [g, REW/3] or [f, 4/FF] to set the time.
4
Press [SHIFT] + [CLOCK/TIMER] to finish setting the
time.
The display will return to whatever was displayed before you set
the time.
To display the time
Press [SHIFT] + [CLOCK/TIMER] once when the unit is on or at
standby mode.
The time is shown for about 5 seconds.
Note
Reset the clock regularly to maintain accuracy.
Convenient functions
To dim the display panel
Remote control only
Press [DIMMER].
The display is dimmed and the indicators are turned off.
(The AC supply indicator remains on.)
Press [DIMMER] again to restore the display.
To mute the volume
Remote control only
Press [MUTING].
Press the button again to cancel.
"MUTING" goes out.
To cancel from the unit, turn [VOLUME] to minimum (--dB), then raise
it to the required level.
Muting is also cancelled when the unit is turned off.