BIOMICROBICS BioBarrier 서비스 매뉴얼 - 페이지 3

{카테고리_이름} BIOMICROBICS BioBarrier에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. BIOMICROBICS BioBarrier 12 페이지.

페이지 인쇄

acceptable for use in surface and subsurface irrigation, including irrigation of edible crops without

the edible portion being in direct contact with the treated water. A reuse tank may be required if the

irrigation system requires it. The holding tank and plumbing system for reuse water shall meet all

applicable codes; have proper backflow prevention and protection against cross connections; and is

the responsibility of the local designer/installer. Additional disinfection should be considered to

provide adequate disinfection to prevent microorganism growth in the treated reuse water storage

EVALUATION OF SYSTEM

PERFORMANCE

A general evaluation of a BioBarrier

performance can be made using some simple

observations which are outlined in the "Trouble Shooting"

guide below. Normal operation of the system should

include the following:

Persons coming in contact with wastewater, must immediately wash all exposed areas with disinfecting cleaner and contact your personal physician. Failure to

do so could result in severe sickness or death.

Only qualified service persons should open any access port or cover on the system. Hazards such as electric shock and Infectious organisms exist in these

areas. Persons coming in contact with wastewater, must immediately wash and disinfect all exposed areas and contact your personal physician. Failure to do so

could result in severe sickness or death.

CONTROL PANEL

When the control panel powered up, the system goes into AUTOMATIC run mode, the "Setting / Information" screen in the front face should

be blank.

Press

button once to reach each in the

"Setting / Information" screen. Line 1 to Line 4 are

display information only, Line 5 to Line 14 allows

changing certain parameters

AUTOMATIC MODE

Automatic mode is the standard running mode for the

system. When the panel is in the AUTOMATIC mode the

blower and pumps operate according to the inputs given

by the float switches, and the settings programmed into

the controller. There are two states of operation when the

system is in AUTOMATIC mode; FILTRATION MODE

(FLIT) and LONG TERM RELAXATION PERIOD (LTRP).

FILTRATION MODE (FILT)

The system is actively filtering wastewater and producing high quality effluent while in this state of operation. The system's

the

position. The system's component operations are:

BLOWER:

DISCHARGE PUMP:

STATE:

Filtration Time:

Rest Time:

system's

OPERATION & MAINTENANCE

Always ON

(On timer) 30 MIN ON, 5 MIN OFF

FILT (Displayed)

Showing how long the system has been

filtering ( HH:MM) and counting up

Showing how long the system has been

resting (HH:MM), in the most recent

LTRP cycle

tank and as required by applicable codes.If a reuse tank is required for irrigation, it shall be located

after the BioBarrier® system. This tank shall also incorporate an overflow that allows excess reuse

water to be dispersed in a locally approved soil dispersal system or released into a sanitary sewer

system. If a potable water make up system is required for irrigation, it shall include a properly

designed backflow preventer that meets all applicable codes.

NORMAL OPERATING CONDITIONS

The BioBarrier

system's blower makes a constant humming noise, much

like a household refrigerator. Under normal conditions, the blower should

SOUND

last 5+ years without need for replacement. If an unusual noise is heard,

refer to the Trouble-Shooting Guide.

A musty, earthy-type of odor is normal. However, if a sewage odor (rotten

SMELL

egg smell) is detected, refer to the Trouble-Shooting Guide.

A properly loaded and operated BioBarrier

SIGHT

that looks like tap water. If the effluent is turbid, opaque, or suddenly

changes, refer to the Trouble-Shooting Guide.

system will produce effluent

BLUE FLOAT

01/01/01

FILT

00:35

will be in

00:00

AUTO

02:56