Axis 01050-001 사용자 설명서 - 페이지 9

{카테고리_이름} Axis 01050-001에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis 01050-001 20 페이지.

AXIS M2026-LE Mk II Network Camera

Additional settings

Turn on the Zipstream functionality and select the desired level.

Note

The zipstream settings are used for both H.264 and H.265.

Turn on dynamic GOP and set a high GOP length value.

Increase the compression.

Turn on dynamic FPS.

Note

Web browsers do not support H.265 decoding. Use a video management system or application supporting H.265 decoding.

Set up network storage

To store recordings on the network, you need to set up your network storage.

1. Go to Settings > System > Storage.

2. Click Setup under Network storage.

3. Enter the IP address of the host server.

4. Enter the name of the shared location on the host server.

5. Move the switch if the share requires a login, and enter username and password.

6. Click Connect.

Record and watch video

To record video you must first set up network storage, see Set up network storage on page 9 , or have an SD card installed.

Record video

1. Go to the live view.

2. To start a recording, click Record. Click again to stop the recording.

Watch video

1. Click Storage > Go to recordings.

2. Select your recording in the list and it will play automatically.

Set up rules and alerts

You can create rules to make your device perform an action when certain events occur. A rule consists of conditions and actions.

The conditions can be used to trigger the actions. For example, the device can start a recording or send an email when it detects

motion, or show an overlay text while the device is recording.

Trigger an action

1. Go to Settings > System > Events to set up a rule. The rule defines when the device will perform certain actions. Rules

can be setup as scheduled, recurring, or for example, triggered by motion detection.

2. Select the Condition that must be met to trigger the action. If you specify more than one condition for the rule, all of the

conditions must be met to trigger the action.

3. Select which Action the device should perform when the conditions are met.