Diatron DT-51S 매뉴얼 - 페이지 6

{카테고리_이름} Diatron DT-51S에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Diatron DT-51S 9 페이지.

Recording

The instrument records in sessions called Events (shown by an E), which start each time the instrument begins recording. Within

Events, time segments (Laps, L on the display) are created with infrared beacon receivers and transmitters or with a store switch. To

end an Event your engine must be turned off, the Exit button must be pressed, or the Tach must go below 200 RPM (this value can be

changed on your PC).

Your instrument is designed to be water resistant. We recommend keeping it as dry as possible. Please cover or remove your

instrument before washing your vehicle. Digatron offers tach bags to help keep the instrument dry. If moisture does get inside the

instrument, remove the endcap without switches and let the instrument air out in a dry environment. A hairdryer, on low power, can

accelerate drying.

If the instrument encounters excessive electrical interference it will display ERR on the left side of the top display. The stored data

might be invalid, and may need to be erased.

To erase your stored data, see Reset on page 4.

The ERR enunciator can also indicate an incorrect instrument or sensor installation. If your instrument is doing strange things, put it

in Set Limits and check to see that the limits and calibration number(s) are still where you set them (see page 5).

Installing a resistance plug boot can normally solve electrical interference problems. We recommend using an NGK boot, #

LB05EMH.

To avoid erratic readings:

♦ Keep your temperature and Tach leads separated by at least 3".

♦ Route the leads as far away from the coil as possible.

♦ Install the Tach lead on the plug wire at least 2" back from the plug boot. If you still have a problem, try a different location on

the plug wire.

♦ Replacing one or all of your sensors often solves this problem.

Please contact Digatron if your problem continues.