Axis 01840-113 다시 칠하기 지침 - 페이지 3

{카테고리_이름} Axis 01840-113에 대한 다시 칠하기 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis 01840-113 8 페이지. Bispectral network camera

AXIS Q8752-E Bispectral Network Camera

Repaint the product

Preparations

•

If applicable, disassemble the device according to the instructions in this document.

•

Clean all parts to be repainted thoroughly to remove grease, dust, or oil.

•

To ensure reassembly and functionality of the product, mask any openings (for example for screws, LED indicators,

or microphones) before you paint.

Pretreatment of parts

Depending on the part material and type of paint applied at factory, different pretreatment should be done for the new paint to

adhere as well as possible. Clean the parts properly to remove oil, grease and dust.

For more information on the materials used in the product, see its datasheet at axis.com.

Powder coated parts - Use a primer. Alternatively, remove the original powder coating down to the base material, using fine

sandpaper, and clean the parts before painting.

Anodised and chromated parts - Use a primer.

Uncoated stainless steel - No special pretreatment is needed, but make sure that the surface is clean before painting.

Plastic - Use a primer.

Disassembly

Important

If you remove any other parts than those specified in this document, it means that the ingress protection (IP) rating of your

product can't be guaranteed. If you remove any additional parts, it will result in lapse of warranty.