Axis 205 설치 매뉴얼 - 페이지 7

{카테고리_이름} Axis 205에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis 205 10 페이지. Axis communications network camera
Axis 205에 대해서도 마찬가지입니다: 빠른 설치 매뉴얼 (6 페이지), (이탈리아어) 사양 (2 페이지)

페이지 인쇄

The Factory Default Settings

If it becomes necessary to reset your AXIS 205 to the Factory Default settings, this can be

done by clicking the Restore button, found in System Options - Maintenance, or by

pressing the Control button, found on the rear panel of the camera. Follow the instructions

below to reset to the factory default settings using the Control button:

1. Disconnect the power cable from the AXIS 205.

2. Press and hold the Control button and reconnect the power cable.

3. Keep the button pressed until the Status Indicator displays yellow (this may take up to

15 seconds), then release the button. When the Status Indicator displays green (which

can take up to 1 minute) the camera will have been reset to the factory default settings.

Note:

Resetting to the factory default settings with the Control button causes all parameters (including

the IP address) to be reset. The camera must then be re-installed. Using the Restore button in the

setup tools will save the IP address, the default router, the subnet mask, the Ethernet/MAC

address and all users and their passwords.

Focusing

Important!

The AXIS 205 may be used indoors only, and must always be positioned where it is not exposed to

direct sunlight or strong halogen light. Exposure to direct sunlight or halogen light may cause perma-

nent damage to the CMOS image sensor in the AXIS 205. Damage as a result of exposure to strong light

is not covered by the Axis warranty.

The focus ring features a

Status Indicator

A small dot is located over the

top of the lens assembly.

raised line.

Focus Ring

AXIS 205 Network Camera

Adjust the focus ring until

the raised line is aligned

with the dot above the

lens. The camera should

now be in focus.

To check the focus, open a

browser and examine the

image. If required, adjust

the ring again, until the

focus is satisfactory.