페이지 인쇄Wireless Series
Battery cover
cycle computer
x4 Pcs
Bracket
Rubber
Bracket
Cycle Computer
Cycle Computer
Bracket
Bracket
Rubber
Rubber
(1)
(2)
Use the rubber to tighten the bracket to the handlebar or stem with the nylon ties.
(3)
Place the cycle computer on the bracket and secure it in clockwise.
Check the position of the front fork to find the suitable point to attach the speed sensor.
The distance between cycle computer & the speed sensor would be with 60 cm.
Mount the sensor with nylon ties on the chosen front fork.
How to mount the Magnet
Screw
Magnet
(5)
(6)
Secure the Speed Magnet on the spoke of the front wheel with screw.
Make sure the magnet side faces the speed sensor zone.
The maximum distance between the speed sensor and the magnet on the spoke is 5 mm.
Once above items in the right position, the user may go for a ride.
Note:Please make sure everything has been setup correctly before riding the bicycle.
Wheel Circumference
To get the accurate result, the wheel size should be correct Mark the symbol on the
tire and ride one circle. Then measure the length between two points to get the
circumference. Or the user can also get wheel circumference by the following
equation:
Circumference(mm) = 2 x 3.14 x R(inch) x
2.54(1 inch=2.54 cm)
R=Radius in centimeter
The user can refer the "wheel size chart"for the
wheel size.
Speed arrow
Comparison
Current Speed
Mode Indicator
Speed unit
Speed
PM indicator
Magnet
Set Key
Mode Key
Press Mode key shortly to change mode.
CLK MODE (Clock Mode)
DST MODE (Distance Mode)
TM MODE (Trip Time Mode)
Nylon Ties
ODO MODE
AVS MODE (Average Speed Mode)
KCAL MODE (Calories Mode)
MXS MODE (Max Speed Mode)
SCAN MODE
In Clock Mode, hold key for 3 seconds to set clock. Press Key to adjust time
(hour,minute,second) Every 3 seconds the display will show the next setting.
M>3s
3s
3s
24H/12H
0~23
12~11,12~11PM
TM MODE (Trip Time Mode)
Trip Timer would operate automatically when the bike is in motion.
Press and hold key for 3 seconds,all exercises results in displayer will
return to zero, except odometer.
M>3s
3sec
TM
TM
AVS MODE (Average Speed Mode)
MXS MODE (Maximum Speed Mode)
The average speed
from the beginning
onwards.
Note:
If the time or distance is over the max value ( 29 hr: 59 min: 59 sec
or Distance: 999.99km), It will not be able to measure correct average
speed by showing "Err" on the display. Once the time & distance value
has been reset, the average speed will show normally.
DST MODE (Distance Mode)
.
Under ODO Mode, press key for 3 seconds to go to setting.
Press key to select Km/H or Mile/H, then wait 3 seconds to go to wheel setting
In Wheel Settings. Input the correct wheel size by pressing key.
Range of wheel size from 100mm to 2,999mm, wait 3 seconds to go to ODO setting
For users to input previous accumulated ODO after new battery
Go to ODO Setting. Input the previous ODO by pressing key, the range
of ODO is from 1 to 99999.
Wait for 3 seconds to go back to ODO Mode.
M
3S..
W.s.10 0~2999
KCAL MODE (Calorie Mode)
It displays the accumulated calories consumed from the beginning of the trip
onwards.
Note: This accumulated calories display will return to 0 once it has been
clear under the TM MODE.
How to input weight, weight scale and gender
M
M
Press key for 3 seconds to setting mode.
Press key to select MALE or FEMALE, and wait 3 seconds to weight unit mode
Press key to select preferable KG or LB, and wait 3 seconds to weight mode
Press key to input the weight in numbers.
Wait for 5 seconds to exit.
3s
3s
SCAN MODE
Under the SCAN MODE, the display will automatically show all modes in
circulating loop every 4 seconds. Once the speed has been detected. Press any key
0~59
0~59
to stop SCAN faeture.
Operating Temperature
Storage Temperature
Battery
TM
Weight
Timer Range : 29 (hour) : 59 (minute) : 59 (Second)
Current Speed Range : 0~99.9 KM / 0~62.4 Mile
Average Speed Range : 0~99.9 KM / 0~62.4 Mile
The maximum speed from
MAX Speed Range : 0~99.9 KM / 0~62.4 Mile
the beginning onwards.
(Trip) Distance Range : 0~999.99 KM / 0~624.99 Mile
Odometer Range : 0~99999 KM / 0~62499 Mile
KCAL:0~99999 kcal
Battery Replacement
Wireless Series computer
Unscrew the back cover. The (+) side should be facing up.
Gently remove the battery and replace it with a new battery model CR2032.
Sensor
Unscrew the back cover. The (+) side should be facing up.
Gently remove the battery and replace it with a new battery model CR2032.
Wireless Series computer
Wireless Series computer
TROUBLESHOOTING
3S
M>3S
Q1. Display is black or very light:
The battery power may be low. Try a new battery to make sure the battery is installed correctly
Q2. Display becomes dark or black:
The unit is too hot. Place the unit in a shaded area, and it will return to normal
Q3. The unit operates slowly or struggled:
The unit is too cold. Warm the unit, and it will return to normal.
M
Q4. Data in display varies enormously:
Check the surroundings for electro magnetic or high energy interference and move
away from the source of interference.
3S..
Q5. Data in display shows slowly:
3S
The unit may be affected by low temperature factor but it didn't influence the function
reading. When the temperature rises, the data reading/ witch will back to the normal.
Q6. Current speed does not appear
It may be caused by the following situation: the distance & position between
magnet and sensor to adjust.
KM:0~999 99, ML:0~624 55
LIMITED WARRANTY
This product is for one year limited warranty commencing on the date of purchase.
The product will be free from defects in material and workmanship for one year
from the date of purchase.
Warranty does not cover the batteries, damages due to misuse,abuse or accidents,
cracked or broken cases, negligence of precautions, improper maintenance or
commercial use.
Warranty is void if the repairs are done by non authorized service technician.
The warranties contained herein are expressly in lieu of any other warranties including
3S
3S
implied warranty of merchantability and/ or fitness for purpose. In no event shall
manufacturer be liable for any damages, direct or incidental, consequential or special,
arising out of or related to the use of this manual or the products described herein.
During this warranty period (one year) the product will either be repaired or
replaced without charge.
kg:20~150
Lb:44~300
Please read over the following information before using the Cycle computer.
Receiver
0
~ 40
℃
-10
~ 50
℃
3 volt lithium 2032 cell
17.7 grams