Connecting the video server to the rack
3. Now refer to Installing on a Network in the AXIS 241Q/S Video Server User's Manual
supplied with the Axis Blade Video Server, keeping in mind the following details:
• Network - connect the Ethernet cable to the Ethernet connector on the rack, in the
position where the video server is to be connected.
• Power is supplied via the Bus Connector, slide the blade video server into the slot.
Make sure that the bus connector is securely connected to the I/O terminal block
connector at the back of the rack. When repeating the installation procedure for each
individual blade video server, simply disconnect the blade video server from the rack
(i.e. do not disconnect the power cable).
• Secure the video server to the rack using the screws on the front panel. The rack
accommodates up to 12 individual Axis Video Servers. To comply with EMC
regulations, ensure that all empty slots are covered using the supplied cover plates.
AXIS 241Q/S Video Server User's Manual
The functionality of the Axis Blade Video Servers is the same as in the standalone versions.
For more information on how to install and configure your video server rack on your
network, please refer to the relevant sections in the AXIS 241Q/S Video Server User's
Manual available in printed format with your AXIS 241Q/S Video Server or on the Axis
Web site at www.axis.com
AXIS 241Q/S Blade - Rack Solution Installation Guide
Please read through the instructions below before
beginning the installation.
1. Connect the power cable to the power connector
on the rack. Make sure that the green power
indicator is lit.
2. Note the Serial number (S/N) on the front panel
on the video server. You need to know this to set
Power
the IP address.
Indicator
7
페이지 인쇄