EasyPro EX6100 설치 및 서비스 매뉴얼 - 페이지 2

{카테고리_이름} EasyPro EX6100에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPro EX6100 4 페이지.

We congratulate you on your choice of the EX4500/EX6100 Centrifugal Pump! It has been carefully designed using the advantages of

today's technology and carefully constructed to give you the dependability of yesterday. To insure proper performance, we urge you to

carefully follow the instructions in this manual. If you have any questions, call your nearest distributor or EasyPro for assistance.

INSTALLATION

Please read carefully! When properly installed the EX Series Pump will provide dependable trouble-free service.

1. Locate the pump as near the water source as possible. A ﬂ ooded suction situation is preferred. The pump is not self-priming, there-

fore, if the ﬂ uid level is below the pump, a swing check valve must be installed and the pump primed prior to start-up. (Figure 2)

2. Mount motor base to a secure, immobile foundation.

3. Use only plastic ﬁ ttings on both the intake and discharge ports. Seal pipe connections with Teﬂ on™ paste. These ﬁ ttings should be

self-supported and in neutral alignment with each port. (i.e. Fittings must not be forced into alignment which may cause premature

line failure or damage to the pump volute.) For non-ﬂ ooded installations, a strainer basket and check valve are recommended.

4. Never restrict the intake. Keep both input and discharge lines as free of elbows and valves as possible. Always use pipe of adequate

diameter. This will reduce friction losses and maximize output.

5. This pump is not self-priming! It must not be run dry! We recommend a ﬂ ooded suction installation. Please read carefully! When prop-

erly installed, the pump will provide dependable, trouble-free service.

(FIGURE 2)

WARNING: ALWAYS SHUT OFF ELECTRICAL POWER BEFORE INSTALLATION AND / OR SERVICING THIS PUMP!

ALL ELECTRICAL WIRING SHOULD MEET STATE AND LOCAL ORDINANCES. IMPROPER WIRING MAY NOT ONLY

BE A SAFETY HAZARD BUT MAY PERMANENTLY DAMAGE THE MOTOR AND/OR PUMP! 230V 50 HZ MOTORS

AVAILABLE - CONTACT YOUR SUPPLIER FOR INFORMATION.

ELECTRICAL HOOK-UP

1. Check that supply voltages match the motor's requirements.

2. Check motor wiring and connect, according to instructions on motor, to match supply voltage.

3. Power cord should be protected by conduit or by cable and be of proper gauge. It should be no longer than necessary.

4. Power should be drawn directly from a box with circuit breaker protection or with a fused disconnect switch.

EX4500 & EX6100

BALL VALVE

SUCTION LIFT

PUMP

Reliability You Can Count On!

FLOODED SUCTION

SWING CHECK VALVE

WARNING: DO NOT RUN DRY!

Pg. 2