EasyPro EXP6500 설치 및 서비스 매뉴얼 - 페이지 2

{카테고리_이름} EasyPro EXP6500에 대한 설치 및 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPro EXP6500 9 페이지. Self-priming external pumps

페이지 인쇄

IMPORTANT SAFETY INSTRUCTIONS

Please read all instructions completely before installing or operating the pump.

Save this manual for future reference regarding installation, operation, maintenance and troubleshooting

of this pump. Please carefully read and follow all safety instructions and procedures listed on the pump

PRESSURE

HAZARD

Do not run your pump with

discharge ports closed or blocked.

Be sure to release system pressure

before working on the pump.

This pump and motor unit should be installed by a qualified electrician or service person in accordance

with all applicable state and local codes and ordinances, and in accordance with the National Electrical

Code. Improper installation may create a mechanical or electrical hazard which could cause damage

to property and could result in serious injury or death.

In order to avoid serious injury or death, always disconnect power to the motor before servicing

the pump and follow all instructions in this manual.

Always use the schematic on the motor for all electrical connections.

Never run the pump dry. The priming pot must be filled with water and lid secured before starting

the motor. Running dry will void the warranty and can result in permanent damage to the pump unit.

To prevent incorrect motor rotation, install a ball or swing type check valve.

Do not use spring check valves.

Maintain a minimum flow rate of at least two gallons per minute to avoid damage to the pump unit.

Visually inspect the pump and motor a minimum of once per week. If any leakage between the motor

and pump housing is present, replace the mechanical seal . The seal faces wear similar to car tires

and must be replaced periodically. For critical applications, replace the mechanical seal yearly. If pump

is excessively noisy, shut it down and contact support.

In freezing environments it is advisable to winterize your pump to prevent damage. Do not allow pump

or system plumbing to freeze, as freezing can cause damage that may lead to equipment failure or

possible injury and will void the warranty.

Scan the QR code at the bottom of page 3 or visit www.easypro.com/exp-series-pumps for pump winterization tips.

SELF-PRIMING EXTERNAL PUMPS

and in this manual.

ELECTRICAL

HAZARD

Ground pump before connecting

to power supply.

Risk of shock, burn or death if not

handled properly.

GENERAL WARNINGS

The All-In-One Pump

BURN

HAZARD

Operating motor can be very hot.

Do not touch motor while running.

Risk of Burn: Allow to cool 30

minutes after shutdown before

handling.

Pg. 2