HTC ONE V 기본 매뉴얼 - 페이지 32
{카테고리_이름} HTC ONE V에 대한 기본 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HTC ONE V 40 페이지. Htc one v
HTC ONE V에 대해서도 마찬가지입니다: 빠른 매뉴얼 (18 페이지)
32 Basics Guide
Regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of
PK76300.
FCC ID: NM8PK76300.
To ensure continued reliable and safe operation of your device, use only the accessories
listed below with your PK76300.
The Battery Pack has been assigned a model number of BK76100.
Operating temperature range: 32°F to 104°F (0°C to 40°C)
NOTE: This product is intended for use with a certified Class 2 Limited Power Source,
rated 5 Volts DC, maximum 1 Amp power supply unit.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.