HTC 420 VS 매뉴얼 - 페이지 26

{카테고리_이름} HTC 420 VS에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HTC 420 VS 50 페이지. Floor grinder | concrete floor sander
HTC 420 VS에 대해서도 마찬가지입니다: 사용자 설명서 (46 페이지)

페이지 인쇄

Operation

4.7. Control

The machines functions can be controlled using the control panel -

see Figure 3-3 on page 9.

During operation, the operator pushes the grinder forward over the

floor surface.

4.7.1. Standby

In order to activate the machines functions, turn thePowerknob

to"I".Once the knob set to this position, the Power indicator on the

control panel lights up, indicating that the machine is in stand by

mode.

4.7.2. Emergency stop switch

The emergency stop switch, (EM-Stop) must only be used in an

emergency.

When the switch is pressed, all electrically-operated equipment in

the machine is turned off.

Note!

Do not use the emergency stop switch to stop the machine other

than in emergencies, as it causes wear to the contactor.

Note!

As long as the emergency stop switch (EM-Stop) is pressed, the

machine cannot be started. Reset by turning the switch 45° so that

it pops out again. The machine can then be restarted.

4.7.3. Starting the machine

For a description of the control panel, see Figure 3-3 on page 9.

Insert the cord.

Make sure the emergency stop switch has not been

activated.

Turn the Power knob to "I" so that the electronics are

activated.

Set the speed for the grinding discs using the Speed knob.

Turn the Grinding knob to "FWD".

HTC 420 VS

2.0