HTC 650 HDX 사용자 설명서 - 페이지 32

{카테고리_이름} HTC 650 HDX에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HTC 650 HDX 48 페이지.
HTC 650 HDX에 대해서도 마찬가지입니다: 매뉴얼 (40 페이지)

Usage

Warning!

Only use cold water with no chemical additives.

4.8. Operation

The machine's functions can be controlled using the control panel -

see Figure 3-3 on page 12.

During operation, the operator pushes the grinder forward over the

floor surface.

To activate the machine's functions, turn the key to the right. When

the key is in this position, the green Power light on the control

panel is lit, indicating that the machine is in standby mode.

The emergency stop switch, (EM-Stop) must only be used in an

emergency.

When the switch is pressed, all the electrically-powered equipment

on the machine is turned off.

Note!

Do not use the emergency stop switch to stop the machine ,other

than in emergencies, as it causes wear to the switch.

Inspect the floor carefully and remove any protruding

objects, such as reinforcement rods or bolts, and any debris

that could otherwise get caught in the machine.

Attach the appropriate tool to the machine.

Set the handle to the working position, see Figure

4-2 on page 17.

Fill the tank with cold water.

Turn the tap on the left side of the machine to the open

position.

Turn the tap to the closed position once wet grinding is

finished.

HTC 650 HDX

1.0