HTC 650 HDX 매뉴얼 - 페이지 27
{카테고리_이름} HTC 650 HDX에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. HTC 650 HDX 40 페이지.
HTC 650 HDX에 대해서도 마찬가지입니다: 사용자 설명서 (48 페이지)
페이지 인쇄
HTC 650 HDX
4.6
Preparations for dry grinding
Note!
The dust extractor's suction hose must be connected to the appropriate socket
on the machine. Adjust the dust extractor to match the grinder's capacity.
1.
Connect a dust extractor to the machine. For available models of dust extractors, go
to HTC's website
Note!
The dust extractor's suction hose must be connected to the appropriate
socket on the machine. Adjust the dust extractor to match the grinder's
capacity.
Note!
The dust extractor can be connected to both sockets found on the protective
cover for the machine. If you only use one of the sockets, the socket not in
use should be covered. Adjust the dust extractor to match the grinder's
capacity.
2.
Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3.
Attach the appropriate tool to the machine, see under Fitting grinding tools, page
19
4.
Set the handle to the working position, see Figure 4-2, page 15.
4.7
Preparations for wet grinding
Tip!
Never use a dust extractor, as it may cause blockages in the dust extractor's
suction hose.
1.
Always use liquid suction when wet grinding.
2.
Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3.
Attach the appropriate tool to the machine, see under Fitting grinding tools, page
19
4.
Set the handle to the working position, see Figure 4-2, page 15.
Warning!
Only use cold water with no chemical additives.
3.0
www.htc-floorsystems.com
for more information.
Operation
21