EasyPro PA66W 설치, 운영, 유지보수 매뉴얼 - 페이지 5

{카테고리_이름} EasyPro PA66W에 대한 설치, 운영, 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPro PA66W 8 페이지. Rocking piston aeration systems

General Assembly Instructions

1. Unpack the aeration system to ensure all parts were received. If a shortage

occurs, please notify EasyPro immediately.

2. Assemble diffusers, detailed instructions included with each diffuser assembly.

NOTE: Video walkthrough of diffuser assembly and installation found at:

easypropondproducts.com/diffuser-assembly

Diffuser Assembly

Check valve shown

here, do not remove.

1. Barbed check valve is designed to

be used with

Remove end of barb if installing

tubing.

3. Use washer on both sides of base.

Insert bolt and tighten nut to clamp

down tubing and provide strain relief.

General Assembly Continued

3. Unroll the entire roll of tubing. It is recommended that the pond diffuser be

installed at this point. This will allow you to trim any unused tubing before at-

taching to the compressor outlet assembly.

4. Connect the valved outlet assembly to the compressor. Once tubing is in

place and trimmed, attach the other end of the tubing to the flexible hose on

the compressor.

5. Open the valves on the outlet assembly to their full open position. Plug the

compressor into a GFCI outlet and adjust each valve to equal the air flow to

each diffuser. This corrects the difference in air flow caused by a difference in

operating depth and/or tubing lengths.

Cut barbed fitting here

for

" I.D. tubing

" and

" tubing.

2. Slip hose clamp over barbed check

valve and push tubing tightly onto

the fitting.

4. Remove plug on the top of the base

and fill about half full (3 to 5 lbs.) with

sand, rock or gravel.