EasyPro Eco-Clear EC2600U 작동, 안전, 보증에 대한 지침 - 페이지 3

{카테고리_이름} EasyPro Eco-Clear EC2600U에 대한 작동, 안전, 보증에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPro Eco-Clear EC2600U 8 페이지. Eco-clear pressurized filters
EasyPro Eco-Clear EC2600U에 대해서도 마찬가지입니다: 작동, 안전, 보증에 대한 지침 (12 페이지)

EasyPro Eco-Clear EC2600U 작동, 안전, 보증에 대한 지침
8. Secure the prepared barb fittings to the filter inlet
(arrow pointing in) and outlet (arrow pointing out).
Be sure to use the gasket as shown and hand
tighten nut onto filter. Do not overtighten.
9. Connect the tubing from the pump to the barbed
fitting on the inlet of the filter and secure with a
clamp.
10. Connect the tubing for the waterfall to barbed
fitting on the outlet of the filter and secure with a
clamp.
11. Run the tubing to the waterfall and attach to a waterfall device if applicable. Burying
the tubing will produce the most natural look for your pond.
12. If the pressure filter unit is equipped with a UV
light make sure it is properly plugged into a GFCI
protected outlet. DO NOT operate the UV light until
the pump is running.
13. For units with UV, there is a connection at the
ballast to be made. Connect the 2-pin fittings by
aligning the ends properly and firmly pushing them
together. Secure by hand tightening the nut to
create a weatherproof seal. This connection is not
meant to be submersed but is good for outdoor
use.
14. Plug in the pump and UV. Observe the filter and
connections for any leaks.
15. Conceal your pressure filter and tubing with your choice of landscaping. Fake rocks
are a good option to hide the filter.

Operation Tips

Running the filtration system continuously is the best way to keep your pond looking its
best. Once installed the filter will take a few weeks to build up sufficient nitrifying bacteria
in the system.
To maximize the filter's performance and avoid ineffectiveness or damage to the filter, be
sure to match the flow rate with the filter's specifications.
These filters are not to be used in the winter during freezing conditions. Be sure to
disconnect and drain the filter to store in a warmer location for the winter.
3
Step 8
Step 13