EasyPro Prelude 설치 지침 - 페이지 3

{카테고리_이름} EasyPro Prelude에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. EasyPro Prelude 4 페이지.

STEP THREE - INSTALLING THE UNDERLAYMENT AND LINER

to leave plenty of extra liner going to the filter box. The liner should not be tight. Trim the excess liner

and underlayment later, after the installation is complete.

STEP FOUR - FINISHING UP

Run the protective underlayment

in the pond and up the stream (if

one is installed). The underlayment

should overhang the stream bed

and be up to the bottom of the filter

box. Lay the liner in the pond over

the underlayment. Work as many

wrinkles out of the liner as pos-

sible. The liner should be run up the stream or to the filter box.

Folder the liner over the Spliner Lock. Slide the Spliner Bar into

the spline channel and secure with the Spliner Locks. Be sure

Lay the filter mats in the bottom of the filter box on top of the sup-

port tubes or support stands depending on model.

Place the supplied Bio-Blox

media bags on top of the filter

pads, making sure they are

snug into the corners. Cover

the top of the filter box with a

flagstone or filter cover.

Stack stones up the front of the

falls filter to conceal the filter box

and liner. Additional stone can be added on top, just below the lip, to

extend the waterfall.

You may also want to put

a piece of flagstone in

the mouth of the falls to

hide the weir and to make

a more natural looking

water feature.

Spillway - End View

"Spliner

Bar"

"Spliner Lock"

Pond Liner