Bionaire BAP529 Series 지침 리플렛 - 페이지 7

{카테고리_이름} Bionaire BAP529 Series에 대한 지침 리플렛을 온라인으로 검색하거나 PDF를 다운로드하세요. Bionaire BAP529 Series 11 페이지. Air cleaner with aer1 filter series

페이지 인쇄

H E P A F I L T E R C L E A N I N G I N S T R U C T I O N S

4. Clean the Foam Pre-filter (reference to Figure 1).

Remove any dust or lint and wash in warm soapy

water. Rinse, air dry before placing back into the air

intake grill.

5. Take out the Carbon filter(s) with the True HEPA

filter(s) by pulling them gently towards you.

6. To clean the True HEPA filter(s), remove the dirty

filter(s) from the unit. Using your vacuum cleaner,

run the brush attachment along both sides of the

filter(s) and clean between the pleated layers (Figure

5). After cleaning, reinstall the cleaned True HEPA

filter(s) back into the unit. The filter side with the

black rubber seal should be facing towards the unit.

NOTE: Ensure proper

assembly of the filter clip

to the filter. Attach the

filter clip and filter

assembly to the air

purifier hang tabs. Make

sure the hang tab is

securely in place. Align

the clip on the side of the

true HEPA filter with the

rails on the inside of the

unit. Gently slide the filter

onto the rail (see Figure

6). The arrows should

point towards the unit.

IMPORTANT: Do not

use household

cleaners or detergents

to clean the filter(s).

If the filter(s) become

damaged during

cleaning, call 1-800-253-2764 to order

replacements.

7. The carbon filter(s) cannot be re-used. Insert new

carbon filter(s) in place after first removing the

plastic bag. Carbon filter(s) need to be replaced

every 3-4 months. Replace the adhesive fasteners if

needed.

NOTE: The air purifier can operate without

installation of carbon filter(s), but carbon filter(s)

absorb and eliminate common household odour, such

as garbage or nursery smells.

8. Install all filters, anti-microbial grill and the air intake

grill onto the unit (see Figure 3).

9. To reset the Filter Indicator timer, press and hold the

Filter Reset button ( ) for 3 seconds only under

working mode when unit is powered on. The Indicator

Figure 5

light ( ) will blink in green 3 times and go off, and

reset the Filter Indicator timer.

10. NOTE: Every time you plug in the air purifier, the

Filter Indicator light ( ) will blink in green 3 times

to indicate that it is checking the filter condition. If

the filter condition is good, the indicator light will

go off. A solid continuously illuminated amber light

( ) indicates the filter(s) need to be cleaned and

will remain lit until filter(s) have been replaced and

filter check reminder has been reset.

NOTE: All filters and front grill must be properly installed

to the unit. If either the grill or the filter is not properly

installed, the unit will not operate.

Figure 6