Bioness Vector base 임상의 매뉴얼 - 페이지 11

{카테고리_이름} Bioness Vector base에 대한 임상의 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Bioness Vector base 18 페이지.

4. Pull the side of the rope that is not connected to the carabiner until the rope connected to the

harness shoulder strap is tight.

5. Repeat steps 1-3 for the other patient harness shoulder strap.

6. Pull on the ropes that are not connected to the harness shoulder straps to adjust the level of

tension in the harness shoulder straps.

7. After the shoulder straps have been properly adjusted, tuck the loose ropes into the back of the

patient harness.

Note: While using the Vector Base System a patient harness may slide up on the patient causing a

decrease in rope tension. If this happens untuck the loose ropes from the back of the harness, adjust

the tension level, and tuck the loose ropes into the back of the harness.

Attachment points for narrow patients

Attachment points for wide patients

Figure 3-2: Spreader Bar Attachment Points

Chapter 3 - Patient Set-Up