Dickey-John INSTALAB 700 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} Dickey-John INSTALAB 700에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dickey-John INSTALAB 700 8 페이지.

INSTALAB 700 QUICK START GUIDE

STARTUP

The Instalab IL700 is powered on by pressing the on/off switch located on the front panel. A series of Startup screens load after

the system is turned on. A status bar will indicate the loading of forms and upon completion, the Instrument Information screen

displays for several seconds before the Main Menu screen displays.

IMPORTANT:

The unit is designed to remain on and not be turned off. If turned off, it is recommended that the unit be

powered on for 3 hours before measurements are taken.

Figure 2

Startup Screens

DICKEY-john Corporation

MAIN MENU SCREEN

NOTE: Regular maintenance routines are recommended for optimum unit performance. Frequency is dependent on

environmental conditions. Refer to the Operator's manual for maintenance instruction.

The Main Menu screen appears after all Startup screens have loaded. The "Home" menu is the main screen that all other screens

are accessed. Main functions available at the Main Menu are analyzing, accessing test results, and system setup.

Power Off

DICKEY-john Corporation

Analyze

Results

Optics Temperature (49.90 degrees C)

performed until the temperature bar is consistently green. Stabilization can take a minimum of 30 minutes but is highly

recommended the unit be on for 3 hours before performing an analysis

Optics Temp

Bar Status

Green

Yellow

Red

Instrument

Information

INSTALAB 700

Setup

Green (normal range)

Red (out of limits/

triggers alarm)

Yellow (out of limits

/no alarm)

Operating Temperature

Limits

Within normal range for analysis +/-.10 degrees C

Optics temperature is within +/-.50 degrees C of set point. Grain

analysis is not inhibited but not recommended.

Optics temperature is greater than +/- .50 degrees C of set point. Grain

analysis is not inhibited but not recommended.

Instrument Info

S/N: 1811-00005

Software Versions: 169.254.0.37

IP Address: 169.254.0.37

Last Update: Nov 04, 2011 (14:44)

Model: IL700

Optics Temperature Thermometer

An optics temperature thermometer displays the

temperature of the optics chamber. The bar is red until the

temperature reading is within +/- .50 degrees C of the

optimum set point of 50.00 degrees C.

green when the temperature is within +/-.10 degrees

C of the setpoint.

Upon power up of the unit, the

temperature will climb to 50.00 degrees C and likely

overshoot. Some oscillation will occur before stabilizing. A

temperature warning appears when the bar is red but

analysis can still occur and is flagged with a symbol

indicating the result is suspect.

IMPORTANT: It is highly recommended that NO analysis is

INSTALAB 700

The bar turns

Instalab 700 Quick Start Guide

11001-1608-201702 Rev B