Dickinson NEWPORT 설치 및 운영 매뉴얼 - 페이지 2
{카테고리_이름} Dickinson NEWPORT에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dickinson NEWPORT 10 페이지. Diesel heater
Dickinson NEWPORT에 대해서도 마찬가지입니다: 작동 및 설치 지침 매뉴얼 (16 페이지), 사용 설명서 (19 페이지)
페이지 인쇄DO NOT ATTEMPT TO BURN OIL FUELS OR GAS FUELS IN THIS APPLIANCE
CERTAIN BRANDS OF ENGENEERED FIREWOOD BURN WITH AN ENHANCED
LEVEL OF HEAT. READ THE INSTRUCTIONS CAREFULLY AND REFRAIN FROM
BURNING ANY MANUFACTURED WOOD WITH AN ARTIFICIALLY INCREASED
THIS HEATER HAS BEEN DESIGNED TO HEAT A SMALL AREA OR AS AN
ESTHETIC FEATURE FOR YOUR BOAT. USE THIS HEATER RESPONSIBLY. DO NOT
WHEN USING ENGENEERED FIREWOOD, MORE FREQUENT CLEANING OF THE
FOLLOW ALL INSTALLATION AND OPERATING PROCEDURES
A PERMANENTLY OPEN FRESH AIR INLET MUST BE INSTALLED TO ALLOW AIR
TO ENTER THE BOAT AND PROVIDE COMBUSTION AIR FOR THE HEATER
WARNING: THIS APPLIANCE AND THE EXHAUST PIPE GETS HOT DURING
OPERATION. CARE SHOULD BE TAKEN TO PREVENT INJURY.
DO NOT OPERATE THIS PRODUCT UNATTENDED
1.
Open the air damper control located on the front of the ash drawer by sliding the
knob to the right side.
2.
Close the sliding panel on the front door by unscrewing the brass thumb screw and
sliding the decorative panel down.
3.
Open the heater door and load a fire lighter or starter onto the fire grate. Ignite and
add sufficient solid fuel for the fire to start. It is important not to overfill the
combustion chamber, (pg 4).
4.
Close the door.
5.
Once the fire is established the sliding panel may be opened
6.
The air damper control can be adjusted to provide fast or extended burning.
WARNINGS AND DISCLOSURES
BTU RATING.
OVERFIL THIS HEATER( pg. 4).
FIREBOX AND THE FLUE MAY BE REQUIRED.
LIGHTING INSTRUCTIONS
1