Dickson TH6 매뉴얼 - 페이지 4

{카테고리_이름} Dickson TH6에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dickson TH6 20 페이지. Temperature chart recorder

페이지 인쇄

Figure 2

TH623/25

(PWR)

LED

ALARM

PEN HOME

If the pen(s) are located on the outside edge of the chart, press the PEN HOME to move pen(s) to recording

position. If the pen(s) are located on the chart, press the PEN HOME key to move the pen(s) to the outside

edge of the chart.

ALARM – (TH623/25)

To set the alarm, make sure unit is on and press and hold the ALARM button. The LED will blink red

rapidly for about five seconds, then the LED will turn solid green. Release the ALARM button and the

LED will turn solid red. At this point the display will show the following: ON or OFF.

Pressing either the ADJUST-UP or ADJUST-DOWN buttons, located on the back of the unit next to the

dip switch, will toggle the alarm on or off.

Pressing PEN HOME will scroll to the next alarm option. The options are as follows:

alarm on or off

pen 1 alarm min

pen 1 alarm max

pen 2 alarm min

pen alarm max

In order to set pen alarm minimums and maximums, pressing ADJUST-UP will increase the alarm value,

and pressing ADJUST-DOWN will decrease the alarm value. There is acceleration if the ADJUST-UP

button is held down. Repetitively pressing the PEN HOME button will scroll through the five options

until the alarm button is pressed to exit from alarm adjust. Each press of the PEN HOME or ALARM

button will store the new settings. The unit will take one minute to exit Alarm Set Mode once the

ALARM button is pressed.

If the alarm is triggered, the LED will show as solid red and the alarm will sound. Press the ALARM

button to silence Audible Alarm.

Rev. 10/07

PEN

HOME

ON/ OFF

Adjust Buttons

Battery

Compartment

TH621/22

(PWR) LED

Figure 3

Relay Contacts

Remote Probe

(TH623/625)

Adapter

Jack

Continued on next page

PEN

HOME

ON/ OFF