dicodes cs1 매뉴얼 - 페이지 6

{카테고리_이름} dicodes cs1에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. dicodes cs1 8 페이지.

dicodes charger cs1: Operation (2)

If no box-mod inserted or with an incorrectly inserted box or with a box-

mod inserted, but without battery inside, the display status will change to

"Detect":

As the charger cannot measure

a battery voltage, there is no

charging current flowing either.

If you inserted a box, with a battery

inside, but the charger still displays

"?", please check the position of the

box inside the inlay to establish contact between the spring pins and mod.

If a wrong inlay is inserted (e.g. "Dani-Box Stabwood inlay" instead

"Dani-Box inlay") or if the inlay/mod

is inserted in the wrong orientation

(turned by 180°) the contacts of the

charger will be shorted by the box-

mod's metal housing. The display

then will show "GND-short" as the

status.

Other status informations are:

"Full"

The battery is fully charged, the charging current is 0. It

might happen, that at the end of a charge cycle the charger

switches back and forth between "Charge" and "Full". This is

OK, but can indicate that the bottom contact of the mod

or the spring pin contacts should be checked to be clean.

"PreCharge" The battery inside the mod is discharged to a level of 2.8V or

below. The charger reduces the current to 260mA until the

battery voltage reaches 3.0V. Above 3V the charge current is

defined by the source strength (up to 2A with provided wall

adapter).

"No Charge" The charger will not charge, if the source voltage is lower

than 4.8V.