EPC EP-Junior 기술 참조 매뉴얼 - 페이지 7
{카테고리_이름} EPC EP-Junior에 대한 기술 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EPC EP-Junior 20 페이지. Dc motor speed control
페이지 인쇄All low power connections are pre-wired into a 6-pin wiring harness (see Figure 1) for
easy installation. All EPC controllers use the same harness connector, and are
interchangeable.
Pin #1 (White Wire)
Connect to the NEGATIVE (-) of your 12 VOLT power supply or battery.
Pin #2
(Red
Wire)
Connect to the POSITIVE (+) of your 12 VOLT power source. This terminal is used to turn your controller
ON. For electric vehicles, this is typically connected to the ignition switch.
Pin #3
(Blue
Wire)
Brake Pedal Switch. Accepts +12V DC input to let the controller know that the brake pedal is depressed.
This instructs the processor to go down to 0% throttle, regardless of the position of the potentiometer. If
your motor is set to run continuously at idle, activating this wire will shut it down until the brake pedal is
released. Although this connection is optional, we strongly recommend using it for automotive (EV and
hybrid) applications.
Pin #4, 5, 6 (Green, Brown, and
Connect to your 3-wire potentiometer. Most standard 0-5k though 0-100k potentiometers can be used.
Figure 1: Controller End Wiring Harness
LOW POWER TERMINAL CONNECTION
Yellow
M = Male Pins
F = Female Pins
Wires)