Epcom EP20M-5B Series 사용자 설명서 - 페이지 9
{카테고리_이름} Epcom EP20M-5B Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epcom EP20M-5B Series 13 페이지. Cell signal amplifier
페이지 인쇄
EP20M-5B Five Band Signal Amplifier
Item
Power Supply
Power Consumption
RF Connector
Impedance
Environment Conditions
Humidity
Operating Temperature
Installation Guides
Installation Requirements
1) With stable and independent power supply.
2) No corrosive gas, smoke or liquid leakage.
3) Sun block and cool for device's safe running.
4) Easy for cabling and dissipation, safe and easy for maintenance.
5) Waterproof and under thunder protection.
Installation Tools
No.
Items
1
Percussion drill
2
Wrench
Mobile phone
3
for testing
4
Multimeter
5
Screwdriver
6
Waterproof tape
Installation Steps
The repeater should be installed on a solid and hard plane. The installation steps are as
follows:
1) Find a suitable site according to the installation requirements and dimension of repeater.
2) Drill 4 holes with the percussion drill according to the installation holes. Sizes are 7mm.
The expected sites of the holes are as the following diagram.
Quantity
1
Drill holes on wall, self-provided
1
Reinforce the interface connection, self-provided
1
Test installation effectiveness, self-provided
1
Test voltage and wiring connection, self-provided
1
Tighten or fasten the device, self-provided
Prevent liquid from leaking into the feeder
A few
interface, self-provided
7
Uplink
DC: 12 V
< 45 W
N-Female
50 ohm
IP 40
< 90 %
0℃ ~ +50℃
Remarks
Downlink