3Com 3CB9LF20R - CoreBuilder 9000 100BTX Switching Module Expansion 설치 매뉴얼 - 페이지 5

{카테고리_이름} 3Com 3CB9LF20R - CoreBuilder 9000 100BTX Switching Module Expansion에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3Com 3CB9LF20R - CoreBuilder 9000 100BTX Switching Module Expansion 13 페이지. 70-km gigabit ethernet gbic transceiver

3Com 3CB9LF20R - CoreBuilder 9000 100BTX Switching Module Expansion 설치 매뉴얼
3 Gently slide the transceiver into the GBIC port until it clicks into place.
4 You are now ready to cable the system to the Gigabit Ethernet network.

Troubleshooting

Transceivers
70-km Gigabit Ethernet GBIC Transceiver Installation Guide
CAUTION: GBIC transceivers are keyed and can be properly inserted only
one way. If the transceiver does not click when you insert it, turn it over
and reinsert it.

Removing the Transceiver

To replace an existing GBIC transceiver, compress the side tabs and gently
pull the old transceiver out of the port.
After you insert the GBIC transceiver into the port, the system software
verifies the transceiver operation, as discussed in this section.
To ensure optimal performance, compatibility, and regulatory compliance,
use only GBIC transceivers that 3Com supports. For a list of currently
supported GBICs, see this 3Com Web site:
http://www.3com.com/gigabit_ethernet/gbics
If the transceiver is not working properly, the system displays an
appropriate error message, as described in the following sections.
"Unqualified GBIC" Error
If the system detects an unqualified GBIC or a problem with the integrity
of the GBIC, it sets the port type to
description at the display (
event log.
WARNING
The GBIC in Port xx is NOT approved by 3Com & may violate
electromagnetic emission or safety requirements for your
country. Refer to 3Com's web page
(www.3com.com/gigabit_ethernet/gbics) for our current
approved list.
Using a newer version GBIC transceiver (GBIC91, GBIC92, or GBIC97) in a
system running older code (pre-Release 3.0) can generate the above
message. For a list of GBIC devices that are qualified for the CoreBuilder
3500, 9000, and 9400, see this 3Com Web site:
http://www.3com.com/gigabit_ethernet/gbics
Unqualified GBIC
), and captures the error in the
Uqual.GBIC
5
, displays a short