Axis 241S Blade 설치 매뉴얼 - 페이지 5

{카테고리_이름} Axis 241S Blade에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis 241S Blade 8 페이지. More video servers in less space – quick, flexible and professional installation and service
Axis 241S Blade에 대해서도 마찬가지입니다: 사양 (6 페이지), 브로셔 (2 페이지), 사양 (2 페이지), 사양 (2 페이지), 사양 (2 페이지), 데이터시트 (2 페이지), 기술 사양 (2 페이지), 사양 (2 페이지), 사용자 설명서 (3 페이지)

페이지 인쇄
Axis 241S Blade 설치 매뉴얼
Bus Connector - Physical interface to the I/O Block Connector on the rack
DIP Switch(es) - A corresponding line termination
switch for each of the supported video outputs (1-4
video outputs depending on the model).
• All units are shipped with the line termination
enabled for each supported video input; that is, with
the DIP switches set to ON (Down position).
• If the AXIS 241Q Blade is to be connected in parallel
with other equipment, disable the input termination
by setting the corresponding DIP switch to OFF (Up
position). Failure to do this can cause the picture
quality to be impaired.
• The AXIS 241S is delivered configured for composite
video input:
Switch
Description
Composite video input
Y/C video input
Axis Video Server Rack
DC-Power
(GND)
Power
Connector
DC+Power
The I/O Terminal Block - the physical interface to a relay switch output and four digital
photo-coupled inputs; also providing an RS-485 interface and an RS-232 serial
connection.
Network Connector - Axis blade video servers are designed for 10 Mbps Ethernet /100
Mbps Fast Ethernet networks and connect to the network via a standard RJ 45 connector.
DC + Power 12VDC Power (output) - This connector can drive the photo coupler inputs or
other equipment such as an IR-sensor. A maximum current (for all pins) of 1000mA can be
sourced from the DC output.
Power Connector - Input power: 100-240 VAC, 50-60 Hz, 1.6A
AXIS 241Q/S Blade - Rack Solution Installation Guide
1
75 ohm video in
75 ohm video out
termination
termination
on
on
Dip Switch(es)
Bus
Connector
2
3
connects video in and
video out
off
on
on
off
5
4
Not used
n/a
n/a
I/O Terminal
Blocks
Network
Connectors