Alpha Microsystems AM-402 설치 지침 매뉴얼 - 페이지 12
{카테고리_이름} Alpha Microsystems AM-402에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Microsystems AM-402 17 페이지. Scsi cd-recorder
페이지 인쇄Page 5
MAKACD then displays information about how much space is required on the CD and where
recording will start.
Calculating space requirements:
MAKACD then gives you the opportunity to abort or to start the recording process.
Note that once started, the recording operation can be stopped by
pressing ^C which will render the CD-R disk unusable.
Warning: The CD-Recorder must receive data constantly. Other users
on the system could delay data transfers and render the CD-R disk
unusable.
Press RETURN to start recording or ^C to abort.
The recording process then begins. As it progresses, status messages are displayed:
Transferring DSK0: in real mode
Transferring DSK6: in real mode
Waiting for CD-recorder to finish writing...Completed.
Also the following information is displayed on the status line:
20% complete
The percentage complete shows how much of the total amount of data has been written to the
CD. The buffer percentage shows how full the CD-recorder's internal cache buffer is.
When all data has been written to the CD in real mode the following messages are shown:
Writing Table Of Contents...
AlphaCD creation complete
And then the CD is ready to use.
REQUIREMENTS AND SETUP
MAKACD requires the following:
•
A 68030 or faster processor
•
A full interrupt enabled SCSI dispatcher.
•
DCACHE, with the number of read-ahead blocks set to 7 for best performance
•
AMOS 2.3A or later.
•
A supported CD-Recorder.
The MAKACD package contains the following required files:
•
The device driver for the CD-Recorder.
•
The CDR.DEV file that contains supported CD-recorder information.
System Commands Reference Manual, Rev. 11
AMOS partition requires 16165 sectors
289735 unused sectors remain
Calculated starting AMOS sector is 0
buffer 95%
MAKACD