Axis S2008 사용자 설명서 - 페이지 15
{카테고리_이름} Axis S2008에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis S2008 18 페이지. Camera station s20 appliance series
Axis S2008에 대해서도 마찬가지입니다: 설치 매뉴얼 (17 페이지), 사용자 설명서 (14 페이지)
페이지 인쇄
AXIS Camera Station S20 Appliance Series
Manage the built-in switch
DHCP server
Admin tab
In the Admin tab, you find information about the firmware version. In this tab you can also change the password, backup settings
and reboot the switch.
Pane
Security
Firmware
Maintenance
Enabled
Start IP address
End IP address
Subnet mask
Gateway
DNS 1
DNS 2
Lease length
Function
Username
Password
New password
Confirm new password
Version
Upgrade firmware
Reset to factory default
Reboot switch
Backup settings
Restore settings
The status of the DHCP server.
When the DHCP server is disabled, you must assign IP addresses manually
to the cameras or use an external DHCP server accessible via the U1
network connection for IP assignment.
When DHCP is enabled, you can choose a Start IP address and End IP
address range for assignment of attached devices
The subnet mask of the U1 switch connection.
The gateway to access the U1 switch connection.
The primary domain name server used by the switch.
An alternate domain name server used by the switch.
The suggested length of time in minutes that the DHCP server will use for
potentially reassigning its pool of dynamic IP addresses. The minimum
lease length is 60 minutes.
Description
These fields allow you to set the password for the switch administrator.
The switch only has one user: admin.
The factory default password is system.
The installed firmware version.
Allows you to update the firmware to a new version.
Resets all switch settings to factory default values.
Reboots the switch. While rebooting, all devices will temporarily lose
connection with the switch (including PoE).
Stores a backup of your settings in a file in the Downloads folder of
your browser.
Allows you to select a saved backup file to restore settings.
15