Epever IPower IP2000-42 사용자 설명서 - 페이지 15
{카테고리_이름} Epever IPower IP2000-42에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epever IPower IP2000-42 20 페이지. Pure sine wave inverter
페이지 인쇄
6. Troubleshooting
Faults
Green indicator slowly flashing
Buzzer sounds
Green indicator fast flashing
Buzzer sounds
Red indicator slowly flashing
Buzzer sounds
Red indicator fast flashing
Buzzer sounds
Green and red indicator on
solid Buzzer sounds
Possible reasons
DC input under voltage
DC input over voltage
Overload
Short circuit
Over temperature
Measure the DC input voltage, if the voltage is lower
than 10.8/21.6/43.2V. Adjust the input voltage to
restore normally.
Measure the DC input voltage, if the voltage is
higher than 16/32
restore normally.
Reduce the number of the AC load.
Restart the inverter.
Check carefully loads connection, clear the fault.
Restart the inverter.
When the heat sink temperature exceeds 80℃ or
the internal temperature exceeds 60℃, the inverter
will automatically stop output; When the heat sink
temperature below 70℃ and the internal
temperature below 50℃, the inverter will resume to
output.
12
Troubleshooting
/
64V. Adjust the input voltage to