Alpha Professional Tools ECC-STAND 기술 노트 - 페이지 4

{카테고리_이름} Alpha Professional Tools ECC-STAND에 대한 기술 노트을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Professional Tools ECC-STAND 4 페이지. Dry tile cutting system

●

Make sure the ECC-125 is connected to the "stabilizer" when assembled to the table. The stabilizer will assure the

Ecocutter will make consistent 90 degree cuts.

●

Make sure the inner belt and outer belt is functioning correctly. These belts drive the pulleys for the fan exhaust that

forces the air flow into the dust bag.

●

Take care to ensure that the cutting area is clear of debris and no one will be in a position to interfere with the

cutting application.

●

Before beginning your cut, allow the tool to run for 15 seconds to inflate the dust bag.

●

Attach side handle for better stability during cutting applications.

●

When transporting your table between jobs, don't place items on top of the rails as it may damage the rails.

●

The ECC-125/225 (Ecocutter), dust bag & hose can be used stand-alone for grout removal, concrete profiling, etc.

●

Have an extra set of belts (inner and outer) on hand.

●

Refer to the Alpha® Ecocutter Dry Tile Cutting System Instruction Manual for proper setup and usage.

●

Read and follow the instructions in the operating manual thoroughly.

Reference

For more product information, visit us on the web at www.alpha-tools.com.

Document # 6030 - Rev.-November 2010

www.alpha-tools.com

Page 4 of 4