Axis 290B 매뉴얼 - 페이지 5

{카테고리_이름} Axis 290B에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axis 290B 8 페이지. Outdoor housing

Connecting the camera

Warning:

Be sure to work inside the housing in dry conditions. Rain water, moisture and prolonged con-

densation inside the housing may cause serious damage to the camera and disturb the picture quality when

in operation.

Warning:

High voltage - the apparatus works on 100-240VAC. Always ensure that the power is discon-

nected before starting any work or opening the housing.

1. Open the housing by releasing the two clips on the side.

2. Strip back the mains power cable by 5mm. The minimum cable conductor area for

installation of the housing is 0.5mm

Warning:

Regulations relating to other parts of the system may require a bigger conductor area. You are

responsible that the requirements of these regulations are met.

Wire the power cables into the terminal block, the cable

with the "+" sign must be wired as shown (+)

Caution:

Ensure that all wires are correctly and securely wired into

the terminal block. No bare wires should be showing. Tighten the

cable tie so that the power cable is held firmly.

4. All models - attach an RJ45 connector (not supplied) to the network cable allowing

sufficient cable to reach the back of the camera. Once you have fitted the connector,

plug it into the network connector at the back of the camera.

AXIS 2420 using a Coaxial cable - attach an RG59 BNC plug to the coaxial cable.

Once you have fitted the BNC plug to the cable connect it to the video output at the

back of the camera.

Important:

Only a 90° BNC angle plug will fit inside the housing. Do not use any other plugs!

290B Outdoor housing

Wiring diagram 290B

(+)