Alpha Scooters Stealth Carbon Gen III 사용자 설명서 - 페이지 3

{카테고리_이름} Alpha Scooters Stealth Carbon Gen III에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Scooters Stealth Carbon Gen III 17 페이지.

페이지 인쇄

Alpha Scooters Stealth Carbon Gen III 사용자 설명서

Carbon Fiber Electric Scooter - Stealth Carbon Gen III

General Electrical Safety

• Inspect electrical equipment, extension

cords, power bars, and electrical fittings for

damage or wear before each use. Repair or

replace damaged equipment immediately.

• Ensure all power sources conform to

equipment voltage requirements and are

disconnected before connecting or

disconnecting equipment.

• When wiring electrically powered

equipment, follow all electrical and safety

codes.

• Wherever possible, use a residual current

device (RCD).

• High voltage / high current power lines may

be present. Use extreme caution to avoid

contact or interference with power lines.

Electrical shock can be fatal.

Riding can be a hazardous activity. Certain conditions may cause the equipment to fail without fault of the manufacturer. The product can and is

intended to move, and it is therefore possible to lose control, fall-off and/or get into dangerous situations that no amount of care, instruction or

expertise can eliminate. If such things occur, you can be seriously injured or die, even when using safety equipment and other precautions. RIDE

AT YOUR OWN RISK AND USE COMMON-SENSE. FAILURE TO USE COMMON-SENSE AND HEED ALL SAFETY WARNINGS AND

RECOMMENDATIONS INCREASES RISK OF INJURY. USE THE PRODUCT ONLY WITH APPROPRIATE CAUTION AND SERIOUS

ATTENTION TO SAFE OPERATION.

• The recommended minimum rider age of 8 years is an estimate only, and can be affected by the rider's size, weight or skills. Any rider unable to

adequately understand the controls or techniques required to ride the product should not attempt to ride it. A parent's decision to allow his or her

child to ride this product should be based on the child's maturity, skill and ability to follow rules.

• DO NOT EXCEED THE WEIGHT LIMIT OF 120KGS. Rider weight does not necessarily mean a person's size is appropriate to fit or maintain

control of the product, moreover the ability of the product to safely support the loads placed on it due to rider weight.

• Always check and obey any local laws or regulations which may affect the locations where the product may be used. Ride defensively. Watch out

for potential obstacles that could catch the wheels or force you to swerve suddenly or lose control. Avoid pedestrians etc who may enter your

path and respect the rights and property of others.

• The product is meant to be used on private property and on closed courses and not on public streets or pavements. Do not ride in any areas

where pedestrian or vehicle traffic is present.

• Do not activate the product unless you are in a suitable environment for safe riding.

• The product is not for indoor use.

• This product was manufactured for performance and durability but are not impervious to damage. Stunts or other aggressive riding can over-

stress and damage the product, and the rider assumes all risks associated with how the product is looked after.

• Be careful and know your limitations. Risk of injury increases as the degree of riding difficulty increases. The rider assumes all risk associated

with aggressive riding activity.

• Maintain a hold on the handlebars at all times.

• Never carry passengers or allow more than one person at a time to ride the product.

• Never use near steps, drops or bodies of water, such as swimming pools.

• Keep your fingers and other body parts away from the wheels and all other moving components.

• Never use headphones or a phone when riding.

• Never hitch the product to another vehicle or person.

• Do not ride the product in rain or wet conditions and never immerse the product in water – electrical components may be damaged by water or

create other possible unsafe conditions.

• Bumpy, slippery, uneven or rough surfaces may increase risks.

• Do not touch the brakes or electric motor when in use and/or immediately after riding as they can become very hot.

• Do not ride at night or when visibility is limited.

E&OE

General Electrical Safety

• Electrically grounded equipment must have

an approved cord and plug and be

connected to a grounded electrical outlet.

• Do NOT bypass the ON/OFF switch and

operate equipment by connecting and

disconnecting the electrical cord.

• Do NOT use equipment that has exposed

wiring, damaged switches, covers or

guards.

• Do NOT use electrical equipment in wet

conditions or in damp locations.

• Do NOT use electrical cords to lift, move or

carry equipment.

• Do NOT coil or knot electrical cords, and

ensure electrical cords are not trip hazards.

Electric Scooter Safety

Appropriate Rider Use and Parental Supervision

Acceptable Riding Practices and Conditions

General Service Information

• The equipment must be serviced or

repaired at authorised service centres by

qualified personnel only.

• Replacement parts must be original

equipment manufacturer (OEM) to ensure

equipment safety is maintained.

• Do NOT attempt any maintenance or repair

work not described in this manual.

• After use, the equipment and components

may still be hot – allow the equipment to

cool and disconnect spark plugs and/or

electrical power sources and/or batteries

from it before adjusting, changing

accessories or performing repair or

maintenance.

• Do NOT adjust while the equipment is

running.

• Perform service related activities in suitable

conditions, such as a workshop.

• Replace worn, damaged or missing

warning/safety labels immediately.