Alpha Solar SolaStat-Eco 설치 매뉴얼 - 페이지 9
{카테고리_이름} Alpha Solar SolaStat-Eco에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alpha Solar SolaStat-Eco 16 페이지. Solar hot water controllers installation guide
페이지 인쇄SolaStat-Eco Operation.
Connect the Pump.
Plug in the pump to the 'PUMP' socket on the SolaStat-Eco. This should be the correct type of
pump for domestic solar hot water circulation and not exceed the horse power (hp) rating as
specified on the label on the side of the enclosure.
Basic SolaStat-Eco Installation.
.
INSULATION
RECIRCULATING PUMP
NON-RETURN
VALVE
COLD FLOW TO PANEL
KEY:
= WATER FLOW.
Note. This diagram is only to be used as a general guide and not all the required components are
shown. Each installation needs to be customised to suit it's situation. Always use best plumbing
and electrical practices, and comply to any regulatory requirements.
Power Up.
Before you connect the power;
1.
Read safety instructions, warnings and limit of liability before proceeding.
2.
Complete all the installation and securely mount the SolaStat-Eco.
3.
Power outlet socket to be installed by a qualified electrician.
4.
Suitable over-current protection and RCD Protection for the SolaStat-Eco and pump is in
place.
5.
There is no water, metal shavings or other electrical hazards to contaminate the plug, socket
and surrounding environment.
Only then;
Plug it in and turn it on.
What You Should See.
The first thing you should see after power up is;
1.
On the top left the 'PWR' light should be on.
2.
Other lights will be on depending on how the solar hot water system is operating.
The pump operation can be tested by pressing the 'PUMP' button. This will turn the pump on as
long as the button is held down, unless of course the pump is already on in normal operation.
The SolaStat-Eco is now installed and should be working. It would be best to observe some solar
hot water pump cycles but this will rely on the sun shining. Check all functions are working correctly
before leaving the installation.
Note 1.
See User Guide for explanation of display and status lights.
Note 2.
See "Trouble shooting" section if system not working correctly.
ROOF SENSOR
HOT RETURN
FROM PANEL
SOLAR COLLECTOR
INSULATION
AIR
TEMPERATURE/PRESSURE
VENT
RELEASE VALVE
VALVE
TEMPERING
VALVE
HOT WATER OUT
COLD WATER IN
INLET SENSOR
COLD WATER INLET
19.03-9
SOLASTAT-ECO
DIFFERENTIAL CONTROLLER
PRE-WIRED
PLUG &
LEAD
.