Accuform Digi-Day 3 지침
{카테고리_이름} Accuform Digi-Day 3에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Accuform Digi-Day 3 2 페이지.
페이지 인쇄
Set-Up & Operate
Your Digital Display
Digital Display
Power Loss Indicator
Segment 1
Segment 2
Power Loss Indicator
In the event of a power loss, the display will go dark, yet will hold in memory
the Number of Days, Date and Time. When power is restored, there will
be an LED indicator on the upper left and the complete display will be red.
The display will resume normal operations – though, time shifted back by
the amount of time power was off. To verify (and reset) the time of day,
remove power loss indicator, and return the display back to green, follow
procedures in Set the "Actual Time" of Day.
Connect Remote Control
STEP 1
to the Digital Display
Your remote control has the capability to connect to five different digital displays.
•
Press and hold the remote "Connect" button
approximately 3 seconds
• The display(s)** will flash the frequency number across all digits
•
Press the same number on the remote control
want to connect
• The display will flash that number in segment 4, four times and resume
normal operation (other displays* will also return to normal operation)
Verify Count-Up Function
STEP 2
Your Digi-Day
display has the ability to count-up OR count-down.
®
•
Press remote "Up/Down" button once
display segment 1, the horizontal bar is to be at the top for "Count-Up"
mode, or at the bottom for "Count-Down" mode.
• To change the Up/Down mode,
• After verifying,
press remote green Enter button.
Display shown in Count-Up mode
8
www.accuform.com
Counter Indicator On Hold*
AM (GREEN) PM (RED) Indicator
Segment 3
Segment 4
(also labeled "1-5") for
of the display you
to verify the correct mode. In
press remote "Up/Down" button.
Display shown in Count-Down mode
)
*Counter Indicator On Hold
To freeze or pause the number of count days,
button.
There will be an LED indicator on the lower right, and the count
will hold or freeze. To resume function, press remote "Hold" button. LED
indicator will turn off.
Your remote control is now connected to the (selected) digital display.
**If there are multiple displays on the board
Example: Display is encoded to 3.
remote "Connect" button (until the display flashes)
Press number 3
on the remote control
single digit will flash four times to signify display
connection is made to the remote control
Set the Number of Count Days
STEP 3
•
Press remote "Count Days" button.
will flash.
•
Press remote's numbered buttons
of days. As each number is entered, the next segment will flash.
• After entering numbers,
Example: 357 days –
Press "Count Days"
number of count days.
Press the green Enter button.
Note: the leading zero(s) will not appear during operation.
800.237.1001
Instructions
Remote Control
Replacement Part No.
SCK325
All Digital Display
functions require the use
of the handheld Remote
Control.
The Remote Control is
programmed to control up
to five (5) different encoded
digital displays. Whether the
Scoreboard has one or five
displays, each can be controlled
individually by following the
'Connect Remote Control to the
Digital Display' steps.
press the remote "Hold" red
Press and hold the
First segment number
to enter desired number
press the green Enter button.
button. Enter numbers 0-3-5-7 for
7
800.394.4001